Technical Safety - Miele PWM 514 Operating And Installation Instructions

Warning and Safety instructions
10

Technical safety


Before setting up the washing machine, check it for any externally
visible damage. Do not install or use a damaged washing machine.

The electrical safety of this washing machine can only be guaran-
teed when correctly earthed. It is most important that this basic
safety requirement is regularly tested, and where there is any doubt
the on-site wiring system should be inspected by a qualified electri-
cian. Miele cannot be held liable for the consequences of an inad-
equate earthing system (e.g. electric shock).

Unauthorised repairs could result in unforeseen dangers for the
user, for which the manufacturer cannot accept liability. Repairs
should only be undertaken by a Miele approved service technician,
otherwise any subsequent damage will not be covered by the guaran-
tee.

Do not make any alterations to the machine, unless authorised to
do so by Miele.

In the event of a fault or maintenance, the washing machine must
be disconnected from the power supply. The washing machine is only
electrically disconnected from the power supply, if
- the plug has been disconnected from the socket, or
- the mains fuse has been disconnected, or
- the on-site screw-in fuse has been completely unscrewed.
See "Installation and connection - Electrical connection".

The washing machine may only be connected to the water connec-
tion using the new set of hoses supplied with the machine. Old sets
of hoses must not be re-used. Check the sets of hoses regularly for
signs of wear. Change the sets of hoses in good time to avoid the risk
of leaks and subsequent damage.

The cause of any leaks must be dealt with before the washing ma-
chine is restarted. Disconnect the washing machine immediately if
any water leaks out.

Steam heating malfunctions can result in high temperatures at the
door, the dispenser and inside the drum (in particular at the edge of
the drum). There is a risk of slight burns.
This only applies to machines with steam heating.

Faulty components must only be replaced by genuine Miele spare
parts. Miele can only guarantee the safety standards of the appliance
when Miele spare parts are used.

All relevant national provisions and regulations (DGUV in Germany)
relating to accident insurance are applicable to this machine. It is re-
commended to carry out testing in accordance with the regulatory
framework described in DGUV100-500 /Chapter 2.6/ Section 4. The
test book required for the documentation is available from Miele.