Setting Beeper Volume; Setting The Handset Volume - Brother FAX 2600 Operation Manual

Setting Beeper Volume

You can set the beeper to LOW, HIGH or OFF. The default setting is LOW.
When the beeper is set to LOW or HIGH, the FAX/MFC beeps every time you
press a key or make an error, and at the end of fax sending or receiving.
1
For the FAX, press Function, 1, 3.
For the MFC, press Function, 1, 1, 3.
2
to select your setting and press Set.
Press or
3
Press Stop to exit.

Setting the Handset Volume

Before you begin to use the FAX/MFC, you must decide if you need to set the
handset volume to AMPLIFY:ON for a user who is hearing-impaired. The
AMPLIFY volume level complies with FCC standards.
VOLUME AMPLIFY: OFF
This default setting is appropriate if none of the users are hearing-impaired.
During a conversation, users can press
the volume. When the handset is replaced, the handset volume remains until you
change it again.
VOLUME AMPLIFY: ON–TEMPORARY
This setting is appropriate if some of the users are hearing-impaired. During a
conversation, users can press
to LOW, HIGH or AMPLIFY. When the handset is replaced, the handset
volume will return to the default setting of LOW.
VOLUME AMPLIFY:ON–PERMANENT
Choose VOL AMPLIFY:ON–PERMANENT if all of the users are hearing-
impaired. During a conversation, users can press
to adjust the volume to LOW, HIGH or AMPLIFY. When the handset is
replaced, the handset volume returns to the default setting of AMPLIFY.
When you press
shows the setting you are choosing. Each key press changes the volume to the
next setting.
WARNING
It is important that you do NOT choose PERMANENT unless all users are
hearing-impaired. Otherwise, the default setting of AMPLIFY may damage
the hearing of some users.
or on the control panel to adjust the volume
or on the control panel to adjust the volume, the display
or on the control panel to adjust
or on the control panel
I N I T I A L S E T U P
4 - 4