Installation
Printer Location
The device and printing materials will be damaged
by moisture and wet conditions.
Set up Brady IP printers only in dry locations
protected from moisture.
Ensure that the foam transportation protection
has been removed from around the printhead.
Place the printer on a level surface away from moisture.
■
Open the Brady IP printer cover (Figure 1, 9).
■
For operation in Peel-off mode, ensure the drivers are set to Peel-off mode
■
and place the printer in such a position that the liner can run down without
hindrance. Refer to Peel-Off Mode on page 21 for additional information
about Peel-off mode.
Printer Connections
Power Supply
The printer is equipped with a universal power supply. The device can be
operated with a supply voltage of 100 to 240 V~, 50 to 60 Hz without
adjustment.
Switch the printer power switch (Figure 1, 8) to the
off position (O) before connecting the printer to the
power supply.
1. Plug the power cable into the power connection socket on the back of the
printer (Figure 1, 6).
2. Plug the power cable into a grounded 100 to 240 V~, 50 to 60 Hz power
source.
NOTE: The Brady IP Printer senses the voltage type and automatically
adjusts for the power source.
6
NOTICE
NOTICE
A
CAUTION