Label Profile - Brady BP-IP300 Operation/Configuration Manual

Label Profile

The Label profile function carries out a longer label advance. It saves the
values measured by the label sensor here and then prints them out in two
diagrams. The printout is used to check label detection in conjunction with the
optical properties of the label medium.
1. Select the label sensor to be tested in Setup > Print param. Refer to
Print Parameters on page 50.
2. Load the label medium to be tested into the printer.
3. Press the menu key.
4. Select Test > Label profile menu.
5. Press the
sensor measures the transparency/reflection capacity of the label
material. The message Test print OK appears in the display once the
advance is complete.
6. Load printable material which extends across the entire printing width.
7. Press the
You can cancel the printout with the cancel key.
key. The printer performs a longer label advance. The label
key to start the diagram printout.
Figure 32, Label Profile
Control Panel
45