Reading The Lcd Display - Brady BP-IP300 Operation/Configuration Manual

Reading the LCD Display

The use of Brady-brand supplies and LabelMark, BradySoft or IdentiLab
labeling software allows access to the full operation of Brady mode. For
detailed information about Brady mode, refer to Brady Mode on page 14.
The LCD display should read Ready and display the type of material loaded
into the printer as well as the type of ribbon loaded. Figure 22 is an example
of a typical display.
1. Designates printer in Brady
mode
2. Online printer status
3. Sensor position
If the printer is in a state other than Ready, refer to the "Basic
Troubleshooting Guide on page 62 to determine what the problem might be.
If the printer is operated with non-Brady software and/or non-Brady labels, the
printer will function only as a standard THT printer. Refer to Standard Mode
on page 16 for additional information.
Loading the Ribbon and Material
1
5
R60XX
4
Figure 22, Typical Ready Display
2
4. Ribbon number and
estimated amount remaining
5. Material part number and
estimated amount remaining
3
27