Print Parameters - Brady BP-IP300 Operation/Configuration Manual

Control Panel

Print Parameters

Press the menu key.
Select Setup > Print param.
Parameter
Heat level
Print speed Basic print speed setting.
Transfer
print
Warn level
ribbon
50
Meaning
Heating value to compensate for different
thermal behavior of printheads. Changing
this value is necessary if the printing intensity
has changed after replacing the printhead.
To adapt the printing intensity when using
different media, print speeds or printing
contents, you should change the heat level in
the software. The settings from the Print
param. menu and the software are added
together.
The heat level setting also affects the test
printouts.
You can specify the print speed for each print
job via software.
The print speed setting also affects the test
printouts.
On for thermal transfer printing: Sensor for
monitoring the transfer ribbon is activated.
Off for thermal direct printing: Sensor for
monitoring the transfer ribbon is not
activated.
You can overwrite the setting for each print
job via software.
Warning sent via the Ethernet interface by
way of an SNMP message or e-mail sent
when the remaining diameter of the ribbon
supply roll undershoots the set value
1.2–3 inches (32–74 mm).
Default
0
100 mm/s
On
Off