Disposal; Troubleshooting - PrimAster PMASH 40 Original Instructions Manual

Cordless pole hedge trimmer
Table of Contents

Advertisement

Available languages

Available languages

GB
ENGLISH

DISPOSAL

If your device should become useless some-
where in the future or you do not need it any
longer, do not dispose of the device together
with your domestic refuse, but dispose of it in an
environmentally friendly manner.
Please dispose of the device itself at an according collec-
ting/recycling point. By doing so, plastic and metal parts
can be separated and recycled. Information concerning
the disposal of materials and devices are available from
your local administration.
Batteries are not to be put into the rubbish. As a consu-
mer you are legally obliged to return used batteries and
accumulators. At the end of the duration of your appara-
tus, the batteries or accumulators have to be taken from
the apparatus, disposing of them separately. You have the
possibility of delivering your old batteries and accumula-
tors to the local collecting points of your municipality or
to your dealer or to the distribution centers.

TROUBLESHOOTING

Warning!
Always remove the rechargeable battery before inspection and adjustment work.
Check the rechargeable battery capacity. If
the charge level is low, this can lead to more
blockages. Continue working with a fully
charged rechargeable battery.
The following table lists error symptoms and
describes how remedial action can be taken
if your machine is not working properly. If
this does not help to locate and eliminate the
problem, contact your service workshop
Cause
Telescopic hedge trimmer is not
working
Telescopic hedge trimmer is
working irregularly
Cutting blade runs hot
Poor cutting performance /
unclean cut
22
Dispose of the batteries when discharged. We recom-
mend applying an adhesive tape on the poles to protect
them against short circuit. Never open the battery.
In observance of European Directive 2012/19/EU on waste
electrical and electronic equipment and its implementa-
tion in accordance with national law, electric tools that
have reached the end of their life must be collected se-
parately and returned to an environmentally compatible
recycling facility.
Recycling alternatives to request for return:
If the ownership of the electronic device is relinquished,
the owner of the device is under obligation to ensure its
proper recycling instead of returning it. For this purpose,
the old device can also be left with a collection facility
that disposes of it in line with the national Recycling and
Waste Act. This does not concern the accessories and
tools without electronic components provided along
with the old devices.
Fault
The battery is empty
The battery is faulty
Loose internal contact
On/off switch is defective
Too much friction due to too
little lubricant
Blunt cutting blade
Remedy
See "Charging the rechargeable
battery"
Have it replaced by our
specialist service department.
Visit a specialist workshop
Visit a specialist workshop
Apply lubricant spray
Sharpen/replace cutting blade

Advertisement

Table of Contents
loading

Table of Contents