Advertisement
U S I N G
The VRS will perform best when
mounted directly on the wall or ceil-
ing. Simply attach the supplied hang-
er to the wall or ceiling, and clip the
speaker to the hanger. If necessary,
you may locate the VRS on top of
furniture or shelving.
You may run speaker wires to the
speaker on the wall's surface or
behind the wall. Use the recessed
area on the back of the speaker to
accommodate wire slack.
For mounting on drywall, paneling,
and other hollow surfaces: Use the
included 6-32 x 2" machine screws
and toggle wings. The toggle wings
1
require a
⁄
" (12mm) hole.
2
For mounting on wood and other
solid surfaces: Obtain a #6 or #8
wood screw.
For masonry, adobe, and other sur-
faces: Consult a knowledgeable
installer about proper hardware. You
will obtain the best results with #6 or
#8 size screws.
Important:
Your speakers have been
packed as a LEFT and RIGHT
matched set. When you place the
speakers, be sure to place the right
speaker to your right as you face the
TV monitor. Place the left speaker to
your left. Hang each speaker so the
arrow on the speaker's label points
to the front of the theater area.
8
T H E
V R S
M O U N T I N G
1. Make two holes for the hanger using the bracket as a template. If running
wires behind the wall, make a wire hole 1" (25mm) below the hanger.
2. Insert a bolt through the hanger and thread onto the toggle wing before
penetrating the wall.
3. Level the hanger and tighten the screws. Connect the cable and hang the
speaker on the bracket so the arrow on the speaker's label points to the
front of the theater area.
W A L L
A N D
B R A C K E T
Face the hooks up
so the speaker may be
hung on them.
29
/
"
32
(23mm)
1"
(25mm)
1
/
Drill
" (12mm) holes.
2
Toggle
wings
Level bracket
before hanging
speaker.
C E I L I N G
6–32 x 2"
Machine screws
Advertisement
