Kits And Accessories - Graco PerformAA 26B570 Instructions Manual

Kits and Accessories

Gun Manifolds
Order manifolds separately; not included with gun
See Parts, page 26.
Part No. Description
288217 Manifold with side fluid ports (North
America)
288218 Manifold with side fluid ports
(International)
288221 Manifold with bottom fluid ports (North
America)
288224 High Pressure Air Assisted Manifold with
side fluid ports and manual fan adjustment
valve (North America)
24C343 High Pressure Air Assisted Manifold
(International)
288160 Rear port manifold (North America)
288211 Rear port manifold (International)
Manifold Accessories
288197 Retrofit Adapter Plate, enables the
manifold to be attached to a variety of bolt
patterns.
Temperature Sensor and Cable
198457 RTD Sensor, 100 ohm, 1/8 npt(m) with 3
pin Picofast connector. For temperature
conditioned manifold
198458 RTD cable, 6 ft. (1.83 m) Flex cable to St.
Clair connector. For temperature
conditioned manifold
Needle/Diffuser Kits
Needles must be used only with the specified
diffuser-seat to guarantee proper seating and life.
Part No. Description
Standard viscosity/standard flow
288191 Fluid Needle, carbide ball
288192 Diffuser-Seat, carbide seat
Acid catalyzed materials/very low viscosity
materials
288190 Fluid Needle, SST ball
288193 Diffuser-Seat, plastic seat
3A8553A
Air Cap Kits
Part No.
249140 HVLP Air
Cap
Verification
Kit
253032 Air Cap Seal
Kit
Spray Tip Kits
AXP and AXF Spray Tip Gasket Assembly and Kits,
page 33
RAC Spray Tip Assembly and Kits, page 35
RAC Conversion Kit 287917
To convert from a gun with standard spray tip, tip
guard, and air cap to Part No. 26B573 gun with the AA
RAC assembly. See parts list and drawing below for
parts included with kit.
Ref.
Part No. Description
No.
46 249478 CAP, air, AA RAC, assy
11 15J770 HOUSING, RAC
9** LTXxxx TIP, cylinder; tip of choice;
includes item 3a; order
separately
9a** TIP GASKET SEAT, assembly
10a 249877 SEAT, diffuser
**Tip (9) is not included with kit; order separately. See
Reverse-A-Clean (RAC) Spray Tips, page 34.
9a
11
46
Kits and Accessories
Description
Use to determine air
pressure behind the air cap.
Do not use for actual
spraying. To be HVLP
compliant, the atomizing air
pressure must not exceed
10 psi (70kPa, 0.7 bar).
Pack of five seals and five
o-rings for the air cap
assembly.
10a
9
TI8126a
Qty.
1
1
2
1
1
37