Rear Suspension; Tire Pressure; Engine Coolant - Suzuki LT-Z400K3 Setup Manual

REAR SUSPENSION

Compression Damping Force Setting
Adjust the setting of the compression damping force
to the standard position. To adjust, turn the adjuster
A clockwise until it stops then turn it counterclock-
wise 2 turns are felt and the two punch marks align.
Standard setting position: 2 turns out
Do not force the adjuster screw A A A A past the
stopped position or you may damage the
adjuster.
Rebound Damping Force Setting
Adjust the setting of the rebound damping force to the
standard position. To adjust, turn the adjuster B
clockwise until it stops then turn it counterclockwise
16 clicks are felt and the two punch marks align.
Standard setting position: 16 clicks out
Do not force the adjuster screw B B B B past the
stopped position or you may damage the
adjuster.

TIRE PRESSURE

Using an accurate air gauge, check the air pressure
of the front and rear tires. The pressure should be as
shown.
COLD INFLATION TIRE PRESSURE
LOAD
FRONT
30 kPa
Up to 110 kg
0.30 kg/cm
243 lbs
4.4 psi

ENGINE COOLANT

The engine coolant level should be kept between the
"FULL" and "LOW" level lines as shown in the photo-
graph. Inspect the level with the vehicle held upright
on level ground.
Please refer to the owner's manual for correct adjust-
ment.
A: Engine coolant reservoir
B: "FULL" level line
C: "LOW" level line
29
TIRE PRESSURE
REAR
27.5 kPa
2 2
0.275 kg/cm
4.0 psi