H
33
Rebound Damping Force Adjustment
Adjust the setting of the rebound damping force to
the standard position. To adjust, turn the adjuster
screw B clockwise until it stops, then turn it counter-
clockwise until 13 clicks are felt.
#
Do not force the adjuster screw B B B B past the
stopped position or you may damage the
adjuster.
Be sure to adjust the damping force on both
front forks equally.
Air Pressure Adjustment
Place a block under the chassis tube to lift the front
wheel off the ground. Remove the air bleed screw C
and equalize the air pressure in the front forks to
atmospheric pressure. Re-fit the air bleed screw C.
NOTE:
The specified front fork air pressure is 0 kPa (0
kgf/cm
, 0 psi) for both fork legs.
2
!
Do not pump air into the front fork.
REAR SUSPENSION
Rebound Damping Force Adjustment
Adjust the setting of the rebound damping force to
the standard position. To adjust, turn the adjuster
screw A clockwise until it stops and then turn it coun-
terclockwise until approximately 11 clicks are felt and
the two punch marks align.
#
Do not force the adjuster screw A A A A past the
stopped position or you may damage the
adjuster.
Low Speed Compression Damping Force Adjustment
Adjust the setting of the compression damping force
to the standard position. To adjust, turn the adjuster
screw B clockwise until it stops and then turn it coun-
terclockwise until approximately 7 clicks are felt and
the two punch marks align.
#
Do not force the adjuster screw B B B B past the
stopped position or you may damage the
adjuster.