Troubleshooting - pro.point 8843880 Manual

8843880
4. Apply a generous amount of air tool oil to the tool before storing it
for an extended period of time (overnight, weekend, etc.). Run the
tool for approximately 30 seconds to ensure the oil is evenly
distributed throughout the tool. Store it in a clean and dry location.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.

TROUBLESHOOTING

Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
PROBLEM(S)
Tool runs at
normal speed, but
loses power under
load.
Tool runs slowly.
Air flows slightly
from exhaust.
Tool runs slowly.
Air flows slightly
from exhaust.
Tools will not run.
Air flows freely
from exhaust.
12
3/8 in. Butterfly Air Impact Wrench
POSSIBLE CAUSE(S)
Motor parts worn.
Motor parts jammed with
dirt particles.
OR
Airflow blocked by dirt.
1. Air regulator in closed
position.
2. Damage or excessive
wearing of internal
parts.
Damage or excessive
wearing of internal parts.
SUGGESTED SOLUTION(S)
1. Have a qualified technician
service the tool.
2. Replace tool or parts.
1. Check air inlet filter for
blockage.
2. Pour air tool lubricating oil
into air inlet as per
lubrication instructions for
clearing shipping grease.
3. Operate tool in short bursts
to clear debris.
4. If tool still jammed, clean
tool and lubricate per
lubrication instructions.
1. Open the air regulator to
desired airflow.
2a. Have a qualified
technician service the
tool.
2b. Replace tool or parts.
1. Have a qualified technician
service the tool.
2. Replace tool or parts.
For technical questions call 1-800-665-8685
V1.0