Pressure Drop; Care And Maintenance - pro.point 8843880 Manual

8843880
5.1 Push on the right side of the paddle to tighten and the left side
to loosen a bolt or nut.
5.2 If the tool stalls while tightening, do not raise the output
pressure of the air compressor above 90 PSI. Pressure above
90 PSI will strip the workpiece and damage the tool,
potentially causing tool failure and serious injury. Use other
appropriate methods and tools to tighten the nut.
6. This tool will stop operation/rotation a few seconds after the trigger
is released.
7. When the fastener is tightened, release the paddle and remove the
tool and socket.
8. Use a mechanical torque wrench to check the fastener torque.
9. When finished with the tool, turn off the air compressor, disconnect
the air hose and discharge any residual air remaining in the tool.
Put the impact wrench away in a safe storage area.

PRESSURE DROP

Apply the air consumption and pressure rate numbers to the tool's air
inlet, not the compressor's outlet. Calculate the pressure drop for your
air supply set-up and increase the compressor outlet pressure to
compensate. Make sure you do not exceed the maximum pressure for
any part of your air supply system.
Installing a pressure gauge at the tool inlet is the best way to measure
the air pressure and adjust the compressor's output.
CARE & MAINTENANCE
WARNING! To prevent serious injury from accidental operation,
turn off and detach the air supply, safely discharge any residual
air pressure, and release the throttle and/or turn the switch to its
off position before performing any inspection, maintenance, or
cleaning procedures.
1. Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2. Inspect the tool fittings, alignment and hoses periodically. Have
damaged or worn components repaired or replaced by an authorized
technician. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
10
3/8 in. Butterfly Air Impact Wrench
For technical questions call 1-800-665-8685
V1.0