Alpha ESS SMILE-S6-HV Installation Manual page 28

Your Smart Energy
5. Install the cardboard limit board on the battery pack with screw M5*12 (X 2) (tool:
T20 screwdriver, torque: 2.5Nm).
6. Place the battery against the wall, align the holes at the battery side to the screw
holes of the wall bracket.
7. Tighten the wall bracket and the battery pack with screw M5*12 (X 2) (tool: T20
screwdriver, torque: 2.5Nm).
If the floor of installation site is uneven, please use floor gaskets to level at the
bottom of the battery pack
WARNING
Risk of injury when lifting the battery pack, or if it is dropped
The battery pack is very heavy. There is risk of injury if the battery pack is lifted incorrectly
or dropped while being transported or when attaching it to or removing it from the wall
bracket.
• Transport the battery pack always as described below.
• It is forbidden to stack 3 batteries from top to bottom.
8. Mounting more batteries
You can install extra batteries up to 6 batteries in a system.
Please install extra batteries by side, also batteries can be stacked up to two bat-
teries per column. Expansion wiring please refer to Chapter 7.8.
1) If you will install extra batteries by side, please repeat steps 1-6 and keep the
distance between two batteries greater than 300mm. The space between the
___________________________________________________________________
Page 28 of 75
.
Alpha ESS Co., Ltd.