Sunrise Medical Quickie Q700-UP M Instructions For Use Manual page 27

7.7.1 Retrieving a Memory Seat
Positio
n (Fig. 7.9 to 7.11)
1. Press the "Mode" button, (A), one or more times until
a seat icon appears in the LCD control panel display.
2. Move the joystick to the left or right to select a memory
seat position:
1. Seated
2. Supine
3. Pressure Relief
4. Forward Tilt
5. Transfer
6. Stand Up
A seat icon and the memorydescription or the relevant
position are shown in the LCD control panel display.
3. Move and hold the joystick forwards. The seat adjusts
to the factory preset position. The movement can be
stopped at any time and started again when moving the
joystick forward.
4. In any of the 6 memory seat positions moving the
joystick backwards brings the seat into the "Seating"
memory position. Once the seat has adjusted to the
saved position, it stops moving.
NOTE:
• Movement of the seat can be stopped at any time by
releasing the joystick.
• During a stop period, another memory position can be
selected with a right or left movement of the Joystick. After
selecting a new Memory position, moving the joystick
forward will operate the seat into the new selected
position.
Fig.7.9
MODE
Fig.7.10
Fig.7.11
247556 Rev. A
PROFILE
A
7.7.2 Return to drive mode
Press the "Mode" button one or more times until a standard
display image with speed indicator appears in the LCD control
panel display.
7.7.3 Saving a new position to memory
1. Remove the rear cover of the backrest and connect a
Switch with a 3.5mm Jack to the socket on the CxSM
(Fig. 7.12).
2. Press the "Mode" bu
icon appears in the LCD control panel displa
Move the joystick to the left or right to select a memory
3.
seat position (Fig. 7.14). A seat icon and the memory
description or the relevant position are shown in the LCD
control panel display (Fig. 7.13).
4.
Move and hold the joystick forwards (Fig. 7.14). The seat
adjusts to the factory preset position. The movement can
be stopped at any time and started again when moving
the joystick forward.
5. Stop the seat movement where required and select with a
left or right joystick movement the seat actuator that
needs to be changed.
6. Move the joystick forward or backwards until the required
position is reached. Select other actuators if required and
move them where needed.
7. Move the joystick left or right until the factory memory
position is reached and where the new position shall be
programmed in.
8. Press and hold the switch connected to the CxSM
(Fig. 7.11) and pull the joystick backwards for 3
secondsuntil a beep can be heard.
9. Release the joystick and the button. Your new required
positio n is n ow stored and the actuators will stop always
in this new programmed end position.
27
tton one or more times until a seat
y (Fig
. 7.13).
Q700-UP M