Sunrise Medical Quickie Q700-UP M Instructions For Use Manual page 15

CAUTION!
• Please check that the new arm rest position does not interfere
with any seat positioning
S et the seat plate wid th
Lift the seat cushion off the Velcro© strips to access the seat
plates.
• Use a 5.0 mm Allen Key, (Hex Wrench).
• Adjust the seat plate width by loosening the four screws, circled
in Fig. 5.2.
Slide the plates outwards or inwards to achieve the required
•
seat width.
• The seat width is indicated by the scale that runs alongside each
slot, Fig. 5.2.
• Tighten the four screws securely.
Set the back plate width
Lift the back cushion off the Velcro© strips to access the back
plate, Fig.5.3.
• Use a 5.0 mm Allen Key, (Hex Wrench).
• Loosen all of the 12 screws located within the slots.
De f ine the back plate width
• Slide the side plates in or out to the required width.
• Tighten the 8 screws securely (white marked in Fig. 5.3).
Positioning/centering the back plate wid th
• Slide the backrest to the left and the right to align with the marker pin.
• Use the measuring scale embedded on the back plates and the marker
pin for reference.
• Tighten all remaining 4 screws securely (black marked in Fig. 5.3).
• Fit a backrest cushion onto the back plate.
CAUTION!
After finishing seat width adjustments, make sure that the armrest can
be flipped up without colliding with the backrest. Not doing so can lead
to damaging the product.
Lift off side cushion
The Q700 -U P M, has the ability to remove the side support
cushion without the use of tools. This facilitates side transfers
especially when the chair is fitted with lateral knee or hip supports.
To remove the side cushion:
• Pull the plastic lever that is attached to the aluminum seat side
rails backwards (Fig.5.4 - A).
• Swing the back part of the cushion outwards to an angle of
approximately 10° - 90°.
• Lift the cushion out from the front pin.
To refit the side cushi on
Align the pin at the front edge of the seat plate with the hole of
•
the aluminium side rail.
•
Slide the rail onto the pin and swing the side cushion all the
way in, until the latch locks in with an audible click.
• As with all moving parts be careful not to trap your fingers
 J3 Back (Fig. 5.5):
NOTE: The Jay 3 Backrest can be used in conjunction with the
Ergo seating system. Please refer to the J3 Back Owner's
Manual for fitting and adjustment.
247556 Rev. A
:
1 5
A
Fig. 5.2
F ig. 5.3
Fig. 5.4
Fig. 5. 5
Q700-UP M