Waterdrop WD-TSA-10 Installation

Triple-Stage Undersink Water Filtration System
WD-TSA-10 system | Installation Instructions
WARNING Please read it carefully before installation.
Inlet hose
Teflon tape
Specifications
Operating temperature 2-38℃/35-100℉
Working pressure 10-125psi (0.7-8.6bar)
Flow rate 1gpm
WD-10PP: up to 6 months
Filter capacity
WD-10GC: up to 8-12 months
WD-10CT: up to 12-18 months
Feed water requirement Municipal tap water
Note: The service life mentioned above is subject to chlorine reduction. Actual result varies according
to the local water quality.
Precautions
• Do not use it with water that's microbiologically unsafe or of unknown quality without adequate disinfection.
• For use only with cold water.
• Do not freeze the lter, as this can cause cracking and water leakage.
• Do not allow children under 3 years old to have access to small parts during installation of this product.
• This installation must comply with all applicable state and local regulations.
• Turn o the water supply while replacing the lter.
Installation of the filter system
Tips: How to disconnect the quick-connect?
Use your thumb and index nger to press down on the lock sleeve. Use your other hand to pull out the
hose from the tting.
Note: Please do not pull out the tubing directly, or else it will damage the tting and cause leakage.
Filter head
Outlet hose
Step 1: Fix the filter head and the filter
1. Paste the assistant label to nish drilling.
Note: Mount the water lter at least 2 inches higher
than the ground for easier lter change.
3/8"-1/2" converter
2. Install the screw and reserve enough space to hang the lter.
3. Hang the lter system on the screw.
Step 2: Connect the water supply (cold water only)
1. Shut o the water supply. Remove the faucet hose. (Figure 1)
2. Connect the inlet hose to the cold water valve.
• If the angle valve outlet is 3/8", it can be directly connected to the water supply. (Figure 3)
• If the angle valve outlet is 1/2", connect it with a No.1 converter at rst. (Figure 4)
Figure 1
Step 3: Connect to the faucet
1. If the angle valve outlet is 3/8", it can be directly connected to the water supply. (Figure 5)
2. If the angle valve outlet is 1/2", connect it with a No.2 converter at rst. (Figure 6)
Press
Pull
Press
Figure 3 Figure 4
①
1/2" outlet
3/8" outlet Connect ① to the cold angle valve
Figure 5 Figure 6
Faucet hose
Faucet hose
Outlet hose
Note: If a female threaded connector is needed, please contact our service team for help.
Step 4: Connect to the filter system
Connect the inlet hose and the outlet hose to the lter head. Make sure the hoses hit the bottom of
the lter head.
Note: When the hose is tightly inserted, there will be a 1/8 inch gap between the hose and the lter
head, which is designed for easy replacement and won't a ect the sealing performance.
Inlet hose
Step 5: Flush the filter and check the leaks
1. Flush the lter for 5 minutes before use.
2. If water leakage occurs, turn o the water supply. If the water leakage is occurring at position 1 and 2,
wrap Te on tape on the external thread. If the water leakage is occurring at position 3 or 4, insert the
quick-connect tting to the end and make sure the hoses hit the bottom of the tting.
Faucet hose
1
Inlet hose
2 3
Hot Cold
Filter system
②
outlet hose
4
Outlet hose