Vehicle Belt Installation - Cosco Scenera NEXT Manual

Vehicle Belt Installation

Do not use LATCH along with
vehicle belts. Store LATCH
when using vehicle belts.
Check vehicle belt before
each use. Use only if belt can
be tightened properly and
securely.
Store tether hook when used
rear facing.
Failure to follow these
warnings can result in serious
injury or death.
33
4358-6590 Scenera NEXT.indd 39-40 4358-6590 Scenera NEXT.indd 39-40
EASE OF USE TIP:
Make sure harness and buckle
fit your child correctly before
installing the child restraint.
See pages 3-4.
1. Place Child
Restraint
Rear Facing
in Back Seat
For children
who cannot sit
up unassisted,
the level line on shell MUST be
parallel with the ground.
For children who can sit up
unassisted, you may rotate the
child restraint to be more upright.
2. Thread Vehicle
Lap or Lap/
Shoulder Belt
Through Rear-
Facing Belt
Path
Review pages 23-25 and your vehicle
owner's manual to determine what kind
of vehicle belts you have.
3. Reach Under
Pad and Pull
Vehicle Belt
1
Across the Shell
2
Belt MUST be in
front of buckle
strap. You MUST
use the 1st or 2nd buckle slot. Do not
place belt over child's legs. Buckle
vehicle belt.
4. Tighten
Belt
Place hand
in child
restraint.
Firmly push down and towards
the vehicle seat back while
pulling shoulder belt or free end
of lap belt to tighten.
continued on next page
10/1/14 10:17 AM 10/1/14 10:17 AM
34