Removing Seat Pad For Cleaning; Installing Harness System - Cosco Scenera NEXT Manual

Removing Seat Pad for Cleaning

XXxxxxxx
You must remove the harness system to remove the pad from the shell.
See pages 11-12.
Remove Pad
Pull pad off
the bottom of
child restraint
and remove
pad.
Do not use child restraint
without the seat pad.
Failure to do this can result in
serious injury or death.
13
4358-6590 Scenera NEXT.indd 19-20 4358-6590 Scenera NEXT.indd 19-20
Cleaning Pad
Machine wash separately with cold
water on a gentle cycle. Do not use
bleach. Tumble dry separately for
10-12 minutes on low heat. Remove
immediately.
Cleaning Harness Strap
Spot clean using warm sudsy water and
damp cloth.
Replace Pad
Starting from bottom of child restraint,
slip pad on shell. Pull harness
adjustment strap through pad. Wrap pad
around the top of shell. Install harness
system, see pages 14-16.

Installing Harness System

XXxxxxxx
1. Place Buckle
in Desired Slot
Buckle MUST
face out.
You MUST use
the 1st or 2nd
buckle slot when child restraint is
used rear facing. Any slot can be
used when forward facing.
2. Pull Metal
Retainer
Completely
Through Pad
and Shell
3. Check
Buckle
Pull up on
buckle to
make sure it
is secured.
The buckle MUST not pull out.
4. Rethread
Harness Strap
With sewn end
of harness strap
loop facing the
buckle, thread
harness strap
down through hip harness slot.
continued on next page
10/1/14 10:16 AM 10/1/14 10:16 AM
14