Aircraft Information - Cosco Scenera NEXT Manual

Feed the slack back into the retractor
while tightening.
• ALR (Automatic Locking Retractor)
These belts lock after pulling the
webbing out and letting the belt go
back into the retractor an inch or two.
With an ALR belt, pull the belt all the
way out before threading through the
child restraint.
Vehicle Latch Plates
• Check Latch Plates
Grasp the tongue portion of the latch
plate (the part that goes inside the
buckle) and pull straight out, inline with
the lap belt.
If the latch plate does not slide up
and down the vehicle belt, you have
25
4358-6590 Scenera NEXT.indd 31-32 4358-6590 Scenera NEXT.indd 31-32
a locking latch plate. You should not
need to use a locking clip.
If the latch plate slides up and down
on the belt, and you have an ELR
retractor, you MUST use a locking clip
to install the child restraint. See pages
45-47.
You may not need to use the locking
clip with a switchable or ALR retractor.
Locking Latch
Plate
Sliding Latch
Plate

Aircraft Information

This restraint is certified for aircraft use.
Use only on forward facing aircraft seats.
Follow instructions for vehicle installation.
Contact the airline for their specific policies.
Some airlines may ask to see a label
stating that this child restraint is certified
for aircraft use.
There is an airplane certification label
located on the side of this child restraint
as shown.
26
10/1/14 10:16 AM 10/1/14 10:16 AM