3.3 Wiring
The CMC-EC01 moves packets directionally from IN (left) to OUT (right), with the
correct wiring method shown below:
After hardware installation is complete, turn on the power and look at parameter P9-60.
The value displayed should be "6", and the word "EtherCAT" should also be displayed. If
not, please check the version of the inverter and whether the card has been correctly
connected. (C2000 of version v2.02 or above may support CMC-EC01)
CMC-EC01 Operation Manual
EtherCAT Communication Card: CMC-EC01
7