Installation And Wiring; How To Install; How To Disconnect - Delta CMC-EC01 Operation Manual

EtherCAT Communication Card: CMC-EC01
3

Installation and Wiring

In this section, we illustrate how to connect CMC-EC01 to VFD-C2000 and the network

3.1 How to Install

How to connect CMC-EIP01 to VFD-C2000 series AC motor drive:
Switch off the power supply of VFD-C2000

Open the front cover of VFD-C2000

Place the insulation spacer into the positioning pin at Slot 1 (see Figure 1) and aim

the two holes on the PCB at the positioning pin. Press the pin to clip the holes with
the PCB (see Figure 2).
Crew up at torque 6~8 kg-cm [5.2~6.9 lb-in.] [0.59~0.78 Nm ] after the PCB is

clipped with the holes (see Figure3) .
CAUTION
Do not remove
this cover,except
for servicing
警 告
禁止移除上蓋，
維修除外。
CL001
+2 +1 B1 B2
DC-
DC+
DC-/DC+ 制? ? 阻
直流共母 ?
+2 +1 B1 B2
DC-
DC+
POWER / MOTOR /
電源 M
3
Figure1

3.2 How to Disconnect

How to disconnect CMC-EIP01 from VFD-C2000
Switch off the power of VFD-C2000

Open the front cover of VFD-C2000

Remove the two screws (see Figure 4).

Twist open the card clip and insert the slot type screwdriver to the hollow to prize the

PCB off the card clip (see Figure 5).
Twist and open the other card clip to remove the PCB (see Figure 6).

Figure 4
6
Figure 2
Figure 5
Figure 3
Figure 6
CMC-EC01 Operation Manual