Environmental Requirements; Connecting The Exhaust Hose - Kodak X-OMAT M35 Installation Instructions Manual

Processors

Hide thumbs Also See for X-OMAT M35:

Service manual (106 pages)

Table Of Contents

Table of Contents

Connecting the Exhaust Hose

The building ventilation system must

draw air to the outside of the building,

so that no air is reused.

[1]

Connect a 7.6 cm (3 inch) EXHAUST HOSE,

not supplied, to the EXHAUST ADAPTER.

[2]

Connect the EXHAUST HOSE to the

EXHAUST DUCT from the building ventilation

system.

[3]

Leave a 5 cm (2 inch) air gap between the

EXHAUST HOSE and the EXHAUST DUCT.

• If the venting is not correct, fumes will corrode equipment and cause artifacts. Do not install the

processor or accessories if the venting is not correct.

• The building ventilation system must draw air to the outside of the building, so that no air is reused.

• The AIR FLOW is correct when the fumes are flowing out of the processor through the EXHAUST

HOSE. Before installing the processor, or at the next service call, do the following to check that the

AIR FLOW is correct.

EXHAUST ADAPTER

981159