Subscribe to Our Youtube Channel
Related Manuals for SKF PTL
Summary of Contents for SKF PTL
- Page 1 Operating manual Drum pump PTL with control cabinet Version Date of issue February 2017 Publication number 951-130-418-1 Languages Country/Countries EN...
-
Page 3: Table Of Contents
7. Technical data ............Or an SKF Service Center, the addresses of which are given on our website: 8. -
Page 4: General
General Meaning of symbols and corresponding information In this manual, the symbols and safety wordings shown on this page are intended to communicate a particular risk to persons, material assets, or the environment. All safety instructions must be respected by person exposed to these risks. -
Page 5: Safety Instructions
CLP regulation (EC 1272/2008), and identified with hazard picto- grams GHS01-GHS06 and GHS08. None of the products manufactured by SKF can be used in con- junction with gases, liquefied gases, pressurized gases in solution and fluids with a vapor pressure exceeding normal atmospheric pressure (1013 mbar) by more than 0,5 bar at their maximum per- missible temperature. -
Page 6: Warranty
SKF and obtaining written permission. All products manufactured by SKF are not approved for use in conjunction with gases, liquefied gases, pressurized gases in solu- tion and fluids with a vapor pressure exceeding normal atmospheric pressure (1013 mbars) by more than 0,5 bar at their maximum permissible temperature. -
Page 7: Approved Lubricants
(e.g. 'oil separation' behavior) in centralized lubrication systems. 2.5 Danger relating to lubricants You can request an overview of lubricant tests offered by SKF from our Service Center. 2.3 Approved lubricants DA N GER ! -
Page 8: Construction
3 Construction The semi-automatic filling system comprises a pneumatic drum pump type PTL and an electric control cabinet. Fig. 1 Filling pump PTL-50-SP1 Legend 1 Quick connector lubricant outlet 2 Grease hose, length 10 m 3 Bleed opening 4 Bleed valve... - Page 9 Fig. 2 Filling control cabinet Legend 1 Signal light power on 2 Signal light Reservoir full 3 Signal light Reservoir empty 4 Button semi-automatic filling 5 Button for forced operation of the pump with red signal light Drum empty 6 Signal light Reservoir empty 7 Disconnector 8 Signal light Reservoir full...
-
Page 10: Commissioning
• Connect the air inlet quick-release coupling pump supply line • Open the air supply • Check the PTL filling pump is correctly connected to the air supply • Start the pump († § 4.2) network (minimal pressure 2,7 , maximal pressure 4 bar) •... - Page 11 Table 1 Control cabinet signal lights Signal light White signal light The control cabinet is switched on The control cabinet is switched off Green signal light (left and right) The lubricant has reached the maximal level in the Normal operation reservoir of the PVP pump.
-
Page 12: Shutdown
Doing so invalidates all war- ranty claims. The system can also be taken back by SKF for disposal if the costs SKF is not liable for damage caused by improper installation, main- are covered. -
Page 13: Technical Data
• Version +701 254 V, 60 Hz, 150 W 8. Spare parts Only original SKF spare parts may be used. It is prohibited for the operator to make alterations to the product or to use non original spare parts and resources. - Page 14 The contents of this publication are subject to the publisher's copyright and their reproduction, even partial, is prohibited without prior written permission. The greatest care has been taken to ensure accuracy of the information contained in this publication, however, SKF declines any responsibility for any losses or damages, direct or indirect, arising from the use of the information contained herein.
Need help?
Do you have a question about the PTL and is the answer not in the manual?
Questions and answers