Thank you for purchasing the Logia 5-in-1 Wireless Weather Station with WI-FI. This User ™ Guide is intended to provide you with guidelines to ensure that operation of this product is safe and does not pose risk to the user. Any use that does not conform to the guidelines described in this User Guide may void the limited warranty.
11. Placing this product on certain types of wood may result in unintended damage to the finish, for which Logia™ will not be responsible. Consult your furniture manufacturer’s instructions for information on wood care. 12. Do not dispose of old batteries as unsorted municipal waste. Make sure to dispose of them properly according to your local guidelines.
PRODUCT FEATURES 1. Wireless 5-in-1 weather sensor measures wind speed, wind direction, rainfall, temperature, and humidity. 2. No calibration needed! The product is fully pre-calibrated and mostly assembled; all you need to do is install it and sync with the included display console. 3.
WIRELESS WEATHER SENSOR SETUP INSTALL BATTERIES 1. Unscrew the door to the battery compartment on the underside of the main sensor unit. 2. Insert three (3) new AA alkaline batteries, making sure the polarities match up with the markings inside the compartment. 3.
Page 11
2. Insert the nut into the hexagonal hole by the sensor and hold it in place, then insert the screw through the other side. Use a screwdriver to tighten the screw. Do not insert the screw fi rst, or the nut may not line up correctly with the designated hole.
Page 12
4. Insert the nut into the hexagonal hole on the side of the stand and hold it in place, then insert the screw through the other side. Use a screwdriver to tighten the screw. MOUNT THE SENSOR OUTDOORS 1. The wireless weather sensor should be mounted in an open area with no obstructions above and/ or around it, so that it can accurately measure the rain and wind.
MOUNTING ON A RAILING 5. The mounting location should be within 492 ft. (150 m) of the location where you will be keeping the display console with few obstructions and relatively clear sightlines. If there are multiple walls/ levels/buildings in between the sensor and the display console, the functionality could be compromised and you will need less space between the two.
Page 14
NOTE: If nothing appears on the LCD display screen after you plug in the power adaptor, use a pin or similar small object to press the RESET button. SET THE LCD DISPLAY VIEWING ANGLE If you have the display console wall-mounted or on a table stand, the viewing angle may need adjustment.
NOTE: Any time you press the RESET key underneath the wireless weather sensor, it generates a down your ID and key for the further setup step. new ID code for pairing with the console, and you will need to press the SENSOR/WI-FI button on the console for the two devices to pair again.
Page 16
3. Once you are connected to the display console, open up your internet or mobile web browser, and enter the following address into the address bar: http://192.168.1.1 (make sure to include the http:// or else the web browser may interpret the address as a search query). We recommend using the latest version of reputable web browsers.
Page 17
Press to complete the setting Select time server NOTES: When the WI-FI setup is complete, your computer or mobile device will return to the default Press to complete the setting WI-FI connection. If it does not, simply open your device’s wireless network settings and manually reconnect.
Page 18
Language: English Press ‘ADVANCED’ icon to view SETUP ADVANCED the advanced settings page Select setting unit Temperature Humidity % Indoor Current offset: 1 Current offset: -5 Outdoor Current offset: -9 Current offset: 10 CH 1 Current offset: 2 Current offset: -5 Temperature calibration section Humidity calibration section CH 2...
Page 19
UPDATING THE FIRMWARE The console supports OTA firmware update capability. Its firmware may be updated over the This display console supports OTA (over the air) Function Firmware and WI-FI System Firmware air anytime (whenever necessary) through any web-browser on a PC with WI-FI connectivity. updates via any web browser (not mobile browser) on a PC that is connected to WI-FI.
Your display console can upload weather data to Weather Underground and/or Weathercloud via your WI-FI router. does not own Weather Underground or Weathercloud, and these instructions are liable NOTE: Logia ™ to change without notice due to changes in either website.
Page 21
4. Write down or screenshot your Station ID and Station Key/Password for reference and to complete the setup process.
Page 22
3. Enter all the requested information into the Create New Device page. When presented with the the "W100 Series" under "CCL" section. for the Link type* selection box select the "Pro Model selection box, choose LOWSC510WB Series under the Logia section. When presented Weather Link", Once you have completed, click with the Link Type selection box, choose Pro Weather Link.
4. Write down or screenshot your Weathercloud ID and Station Key/Password for reference and to complete the setup process. Jot down your ID and key for the further setup step. When you first power up the console, or press and hold the ACCESSING WEATHER DATA ONLINE seconds in normal mode, the console LCD will show "AP"...
4. Click on either Current, Wind, Evolution, or Inside to view your weather station’s data. ", " ", " " icon to view the live data of your weather OTHER CONSOLE SETTINGS AND FUNCTIONS he console supports OTA firmware update capability. Its firmware may be updated over the r anytime (whenever necessary) through any web-browser on a PC with WI-FI connectivity.
Page 25
Northern Hemisphere Icons Moon Phase Southern Hemisphere Icons New Moon Waxing Crescent Moon First Quarter Moon Waxing Gibbous Moon Full Moon Waning Gibbous Moon Third Quarter Moon Waning Crescent Moon POINTING THE WIRELESS WEATHER SENSOR TO SOUTH The outdoor wireless weather sensor is calibrated to be pointed North for maximum accuracy. However, for your convenience, if you are a user located in the Southern Hemisphere, you can use the sensor with the wind vane pointing South.
Page 26
SETTING THE ALARM If you’d like to use your display console as an alarm clock, follow these instructions to set the alarm time: 1. In normal operating mode, press and hold the ALARM button for two (2) seconds until the alarm hour starts flashing.
Page 27
TEMPERATURE/HUMIDITY & TRENDS Press the °C/°F button to switch between Celsius and Fahrenheit temperature measurements. The arrows show the trend in changes to the temperature/humidity levels. Arrow Icon Temp/Humidity Trend Rising Steady Falling NOTE: • If/when the temperature outside falls below -40°F (-40°C), the LCD display will show the word “Lo”...
Page 28
3. If the signal for the outdoor channel has been interrupted and does not recover within 15 minutes, the signal icon will disappear. The temperature and humidity section (outdoor) will display “—” on the corresponding channel. 4. If the signal still does not recover within 48 hours, the “—” display will become permanent. You will The console display signal strength for the wireless 5-IN-1 sensor, as per table below: need to replace the batteries on the associated channel’s sensor and press the SENSOR/SYNC button to pair up the sensors again.
Page 29
→ → → Umbrella use becomes difficult. 2. Press the WIND button again to return to normal display mode. 3. Press the WIND button while in normal operating mode to switch between AVERAGE and GUST wind speeds. Effort needed to walk Wind Speed Level Chart Level Light...
Page 30
≥ 32.7m/s at the same rate at which it evaporates. The condensed a solid surface. Effort needed to walk mined by the temperature & humidity data from wireless WEATHER FORECAST The built-in barometer can notice atmospheric pressure changes, and based on the data collected, can predict the weather conditions in the forthcoming 12-24 hours within a 19 ~ 31 mile (30 ~ 50 osphere pressure changes.
Page 31
e rainfall and rain rate RAINFALL The Rainfall shows information regarding the rainfall and rain rate. or 2 seconds to enter unit setting mode. Set the Rainfall Units le the rainfall unit between mm and in. 1. Press and hold the RAIN button for two (2) seconds to enter unit setting mode. and exit the setting.
Page 32
indoor (or current channel) MAX temperature > indoor (or current channel) MIN temperature > indoor (or current channel) MAX humidity > indoor (or current channel) MIN > humidity outdoor MAX temperature > outdoor MIN temperature > outdoor MAX humidity > outdoor MIN humidity > MAX average wind speed >...
Page 33
Indoor Temperature High Alert Indoor Temperature High Alert 40°C 40°C -40°C ~ 80°C -40°C ~ 80°C Indoor Temperature Low Alert Indoor Temperature Low Alert 0°C 0°C Indoor / CH Indoor / CH Wind Speed Alert Wind direction & speed temperature & humidity temperature &...
ound for 2 minutes and the related alert icon and minutes, the alert icon and readings will still keep CARE AND MAINTENANCE alert range. e weather readings falls into the alert range again. BATTERY REPLACEMENT If the low battery indicator icon is displayed in the outdoor temperature and humidity section or the corresponding CH section of the LCD console display, this indicates that the batteries in your wireless weather sensor are running low and should be replaced.
SPECIFICATIONS DISPLAY CONSOLE SPECIFICATIONS DISPLAY CONSOLE General Specifications 5.4″ x 6.6″ x 1″ (117 x 189 x 31mm) Dimensions (W x H x D) 0.82 lb. (370g) with batteries Weight Power source DC 5V, 1A adaptor Backup battery CR2032, 3V battery Operating temperature range 23°F ~ 122°F (-5°C ~ 50°C) WI-FI Communication Specifications...
Page 36
Weather forecast Sunny, Partly Cloudy, Cloudy, Rainy, Rainy / Stormy and Snowy Display modes Current Memory modes Historical data of past 24 hours, daily Max / Min Alarm Pressure change alert Indoor / Outdoor Temperature Display & Function Specifications The following details are listed as they are displayed or operate on the console. Note: Temperature unit °C and °F...
Page 37
Display modes Current Memory modes Historical Data of past 24 hours, daily Max Rainfall display mode Hourly / Daily / Weekly / Monthly / Total rainfall Alarm High Hourly Rainfall Alert Weather Index Display & Function Specifications Note: The following details are listed as they are displayed or operate on the console. Weather index mode Feels like, Wind Chill, Heat Index and Dew point Beaufort scale...
Page 38
WARRANTY INFORMATION ™ LIMITED WARRANTY ON LOGIA 5-IN-1 WIRELESS WEATHER STATION WITH WI-FI THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE. WE WARRANT THAT DURING THE WARRANTY PERIOD, THE PRODUCT WILL BE FREE FROM DEFECTS IN MATERIALS AND WORKMANSHIP.
5-in-1 Wireless Weather Station with WI-FI, please contact us before If you experience any issues with your Logia ™ returning your product to the place of purchase. We’re here to help! QUESTIONS OR PROBLEMS? CONTACT US! Email: info@supportcbp.com or call: 1-833-815-0568...
Page 40
LOGIA is a trademark of C&A IP Holdings, LLC, in the U.S. Android is a trademark of Google LLC. Apple and App Store are trademarks of Apple Inc. in the U.S. and other countries. IOS is a trademark of Cisco in the U.S. and other countries and is used under license.