Installation - Spypoint CELL-LINK User Manual

Installation

INSTALLING AND CONNECTING THE CELL-LINK
To connect the SPYPOINT CELL-LINK to your trail camera from any brand,
follow these steps.
We recommend that you watch our video which will guide you through the
different installation steps. Go to www.spypoint.com/en/support.
1. Open your camera door.
2. Take the cable with SD adapter and insert
the SD card extremity (#CL-CBL) in the corres-
ponding slot.
3. Pull the cable with SD adapter down and hold
it against the camera. We suggest that you
make at least one loop with the cable and
place it inside the camera housing. This way,
the SD card will not be disconnected if the
cable is pulled (when you close the camera
door, for example). The cable should therefore
hang freely on the outside of the camera.
Important: Avoid running the cable in front
of the lenses or other essential components.
4. Shut the camera door and lock the latch.
5. Run the cable behind the camera and upwards
so that the end of the cable sticks out of the
top of the camera, so that you can connect it to
the CELL-LINK.
6. Mount your camera to the tree (the cable with
SD adapter should now be placed between the
tree and the camera.)
7. Mount the CELL-LINK above the camera so that
it sits closely to the extemity of the cable with
SD adapter.
8. Plug the extremity of the cable with SD adapter
to the CELL-LINK and screw it on tightly.
You can now access CELL-LINK photos,
configurations, and statuses either via the
SPYPOINT app or the SPYPOINT website.
SPYPOINT
CELL-LINK
13