Table of Contents
Advertisement
en Basic operation
7.2 Switching off the appliance
Press
to switch the appliance off.
▶
a The appliance will now shut down. Any functions
currently in progress will be aborted.
a The time will appear on the display.
7.3 Starting the appliance
To start the appliance, press
▶
7.4 Pausing or cancelling operation
You can cancel operation at any time.
To pause operation, open the cooking compartment
1.
door or press
a The fan may continue to run after operation has
been paused or stopped.
To resume operation, close the cooking compart-
2.
ment door or press
To cancel operation and clear all the settings, press
3.
.
a The appliance stops any ongoing functions.
7.5 Filling the water tank
The water tank is located next to the cooking compart-
ment. You will need to fill the water tank before starting
any operation that uses steam.
WARNING ‒ Risk of scalding!
Hot steam may escape when you open the appliance
door. Steam may not be visible, depending on the tem-
perature.
When opening the door, do not stand too close to
▶
the appliance.
Open the appliance door carefully.
▶
Keep children at a safe distance.
▶
The water in the evaporator dish is still hot even after
the appliance has been switched off.
Never empty the evaporator dish immediately after
▶
switching off the appliance.
Allow the appliance to cool down before cleaning.
▶
When you open the appliance door, hot water may flow
out of the appliance.
When opening the door, do not stand too close to
▶
the appliance.
Open the appliance door carefully.
▶
Keep children away from the appliance.
▶
If the evaporator dish overflows, do not pour more
▶
water into the water tank.
ATTENTION!
Using unsuitable liquids may damage the appliance.
Do not use distilled water, highly chlorinated tap wa-
▶
ter (>40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
▶
non-carbonated mineral water.
Requirement: The water hardness range is set cor-
rectly. → Page 8
Open the appliance door.
1.
10
.
.
again.
Remove the water tank from the tank recess.
2.
Fill the water tank with cold water up to the max
3.
mark.
Close the tank lid.
4.
Slot the full water tank back into the water tank re-
5.
cess.
Check that the front end of the water tank is flush
6.
with the opening of the water tank recess.
Close the appliance door.
7.
Advertisement
Table of Contents
