Key Features - QDI P5I945P Manual

Introduction
Form factor
ATX form factor of 305mm x 244mm
Microprocessor
Supports Intel LGA775 processors
Supports Pentium 4 500,600 series;Pentium D 800,900 series;Celeron D 300 series
System memory
Supports dual channel DDRII 400/533/667MHz
Supports 256Mb/512Mb/1Gb technology up to 4GB
Provides four 240-pin DDRII interfaces
PCI Express x16 Graphics
PCI Express 1.0a specification compliant
Supports one PCI Express x16 port
PCI Express x1 Ports(optional)
PCI Express 1.0a specification compliant
Supports two PCI Express x1 ports
Onboard IDE
Supports three IDE interfaces
IDE1 supports two IDE devices
IDE2, IDE3 support IDE RAID function(option)
Onboard LAN(optional)
10/100(available on -L mainboard)/1000(available on -K mainboard) Mbit/sec Ethernet
support
10/100(available on -L mainboard)/1000M(available on -K mainboard) LAN interface
built-in on board
USB 2.0
USB 2.0 compliant, operates at 480Mbps
Provides 8 USB 2.0 ports
Onboard I/O
One floppy port supporting up to one 3.5
Two high speed 16550 compatible COMs with 16 byte send/receive FIFO (COM1 on
back panel,COM2 on header with optional cable(option))
One parallel port supports SPP/EPP/ECP mode
Supports PS/2 mouse and PS/2 keyboard
Provides one IrDA connector(option)
All I/O ports can be enabled/disabled in the BIOS setup
Onboard Audio
Provides onboard Line-in Jack, Microphone-in Jack and Speaker-out Jack
6-channel Onboard Audio(available on -6A mainboard)
AC'97 2.3 Specification Compliant
Provides Front left&right, Rear left&right/Line-in Jack and Center&Woofer/Microphone-
in Jack,which can be specified by software
8-channel Onboard Audio(available on -8A mainboard)
High Definition Audio(HDA)Specification Compliant
Provides Center&subWoofer speaker out, Rear speaker out, Side speaker out, line in,
Front speaker out and Mic in
''
floppy drives with 1.44M format
2
P5I945P(G)