Table of Contents
Advertisement
Chapter 3
Set Supervisor/User Password
Changes, sets, or disables password. It allows you to limit access to the system and the
setup program.When this function is selected, the following message appears at the
center of the screen to assist you in creating a password.
ENTER PASSWORD
Type the password, up to eight characters, and press <Enter>. The password typed now
will clear any previously entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press <Enter>. You may also press
<Esc> to abort the selection.
To disable password, just press <Enter> when you are prompted to enter password. A
message will confirm the password being disabled. Once the password is disabled, the
system will boot and you can enter BIOS Setup freely.
PASSWORD DISABLED
If you have selected "System" in "Security Option" of "BIOS Features Setup" menu, you
will be prompted for the password every time the system reboots or any time you try to
enter BIOS Setup.
If you have selected "Setup" at "Security Option" from "BIOS Features Setup" menu, you will
be prompted for the password only when you enter BIOS Setup.
Supervisor Password has higher priority than User Password. You can use Supervisor
Password when booting the system or entering BIOS Setup to modify all settings. Also you
can use User Password when booting the system or entering BIOS Setup but can not
modify any setting if Supervisor Password is enabled.
Load Optimized Defaults
The Optimized Defaults are common and efficient. It is recommended users load the
optimized defaults first, then modify the needed configuration settings.
Save & Exit Setup
Saves value changes to CMOS and exits setup.
Exit Without Saving
Abandons all CMOS value changes and exits setup.
P5I945P(G)
21
Advertisement
Table of Contents
