Suzuki RM-Z250L9 Easy Set-Up Manual page 14

S-HAC SWITCH
Hook the holders on the grooves of the S-HAC switch.
NOTE:
Use the holder with an internal thread cutting at the
front side.
A: S-HAC switch
B: Holder (Front)
C: Holder (Rear)
D: Thread cutting
Install the S-HAC switch to the left of handlebars.
NOTE:
Align the matching mark on the handlebars with
mating surface of the S-HAC switch holder.
 S-HAC switch screw: 1.3 N·m (0.13 kgf-m)
A: S-HAC switch
B: 4 × 14 mm screw (with lock washer)
C: Matching mark
ENGINE STOP SWITCH
Hook the holders on the grooves of the engine stop
switch.
NOTE:
Use the holder with an internal thread cutting at the
lower side.
A: Engine stop switch
B: Holder (Upper)
C: Holder (Lower)
D: Thread cutting
Install the engine stop switch to the left of handlebars.
NOTE:
• Align the engine stop switch with the S-HAC
switch.
• Set the protrusion of engine stop switch come in
contact to the clutch lever holder.
 Engine stop switch screw: 1.3 N·m (0.13 kgf-m)
A: Engine stop switch
B: 3 × 14 mm screw (with lock washer)
C: Protrusion
D: Clutch lever holder
13