Brake Disc - Suzuki RM-Z250L9 Easy Set-Up Manual

FRONT
FRONT
This photograph is This photograph is
not for this model. not for this model.
FRONT
REAR
This photograph is This photograph is
not for this model. not for this model.
CLAMP
Clamp the engine stop switch wiring harness and S-
HAC switch wiring harness to the handlebars with
strap.
A: Strap L:100 mm
B: Strap L:130 mm
C: Engine stop switch wiring harness
D: S-HAC switch wiring harness
E: Handlebars

BRAKE DISC

To prevent brake squeaking and pad contamination,
carefully clean the front and rear brake disc plates with
alcohol or other non-petroleum based solvent.
This will remove the rust-preventive coating and dirt.
TAKING OUT THE MOTORCYCLE
Bind a hoist band around the handlebar clamps as
shown in the photograph.
Binding a hoist band to the handlebar or grips
can damage the motorcycle parts.
Be sure to bind a hoist band around the handle-
bar clamps.
A: Hoist band
1. Lift the front of motorcycle by using a hoist.
2. Raise the rear of motorcycle.
3. Pull the crate base forward, then balance the
motorcycle.
14
NOTICE