Installing Ni-Dcpower; Installing The Hardware - National Instruments PXI-4110 Getting Started Manual

Installing NI-DCPower

NI-DCPower features a set of operations and attributes you can use to
programmatically configure and control the NI DC power supply. Install
or upgrade NI-DCPower before installing new hardware so Windows can
detect your device. To install NI-DCPower, complete the following steps:
1. Insert the NI-DCPower CD. The NI-DCPower installer should open
automatically. If not, select Start»Run, and enter
where is the letter of the CD drive.
x
2. Follow the instructions in the installation prompts. For troubleshooting
and operating system-specific instructions, refer to the Hardware
Installation/Configuration Troubleshooter at
.
install
Windows Vista Users may see access and security messages during
installation. Accept the prompts to complete the installation.
3. When the installer completes, a dialog box appears that asks if you want
to restart, shut down, or restart later. Select Restart.
4. If you are using a system running the LabVIEW Real-Time Module,
download NI-DCPower to the target using MAX. Refer to the
Measurement & Automation Explorer Remote Systems Help by selecting
Help»Help Topics»Remote Systems in MAX.
If you install NI application software after installing
Note
NI-DCPower, you must run the NI-DCPower installer again to
install the correct application software support.

5. Installing the Hardware

Make sure you install the software before you install the
Note
hardware.
Caution
the NI PXI-4110 using the metal bracket or edges. Refer to the Read
Me First: Safety and Radio-Frequency Interference document for
more information.
© National Instruments Corporation
To prevent damage due to ESD or contamination, handle
ni.com/support/
5 NI DC Power Supplies Getting Started Guide
x:\setup.exe
,