Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
In the Event of Trouble with Regular Telephone Service
Federal Communications Commission (FCC) Part 15 and Part 68 Statement
Telco-Provided Coin Service Advisement
Summary of Connections
ADEMCO Limited Warranty
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In The Event Of Trouble With Regular Telephone Service
In the event of trouble with regular telephone service, disconnect the security system from
the phone lines by removing the plug from the RJ31X (CA38A in Canada) wall jack. We
recommend that you demonstrate removal of this plug to the user, following installation of
the system.
Do not disconnect the phone connection inside the Control or the 4286 VIP Module.
Doing so will result in the loss of regular phone service.
If the regular phone works correctly after the plug has been disconnected from the RJ31X
(CA38A in Canada) wall jack, the Control Panel or the 4286 VIP Module has a problem
and the faulty unit should be returned for repair. If upon disconnection of the plug, there is
still a problem on the line, the telephone company should be notified that they have a
problem and that prompt repair service is needed.
IMPORTANT: If the phone service is at fault in the test above, re-insert the plug immedi-
ately; if the security system is at fault, re-insert the plug as soon as the security system is
repaired, since the security system relies on this connection for communication with the
alarm monitoring station.
The user may not under any circumstances (in or out of warranty) attempt any service or
repairs to the system. It must be returned to the factory or an authorized service agency
for all repairs.
S E C T I O N
Appendices
6
A-1
Advertisement
Table of Contents
