Table of Contents
Advertisement
In a 4140XMP Installation, Descrip-
tions of Zones Annunciated Are Not
Correct.
• In an existing 4140XMP installation, all
zone descriptors must be re-programmed
when the 4286 VIP Module is installed.
"See System Keypad" Message Is An-
nunciated.
This message will be annunciated during
any of the following conditions:
1. When the system is in the TEST mode.
2. When the system has been set to the
House or Transmitter ID "Sniffer" modes.
3. Four or more unsuccessful attempts have
been made to access the system from off-
premises, which has caused Remote
Phone Access to be turned off automati-
cally.
4. Low battery in an RF transmitter.
5. Modem connection with PC downloader
(down-loading in progress).
6. There has been a failure of the system to
communicate with the central alarm
monitoring station.
7. There has been a 4281 or 5881 Receiver
Set Up Error (more RF zones have been
programmed than can be accommodated
by the type of receiver used).
When the "See System Keypad" message
is annunciated under the conditions listed
in 1 through 7 above, the keypad will pro-
vide the display normally expected under
those particular conditions. For example:
1. If System is in the TEST mode. In this
mode, a fixed-word keypad will only dis-
play the normal "System Disarmed" mes-
sage, while an Alpha key-pad will display
"Test in Progress", unless a zone is
faulted, in which case the zone number
(and the description if it is an Alpha key-
Section 5. Troubleshooting
pad) of the open zone will be displayed. If
System is in the House or Transmitter ID
"Sniffer" mode. Any display that appears
is used to identify ID numbers for specific
identification purposes in this special
mode (used only during installation of the
system).
2. If "Tampering" has caused "CALL-IN
TO
SYSTEM
OFF,
KEYPAD" message to be annunciated.
If the system is in the disarmed mode, an
Alpha keypad will display "CALL-IN
TAMPER" and a fixed-word keypad will
display "CI". However, if the system is in
the armed mode, only the normal "System
Armed" message will be displayed.
3. If there is a low battery in an RF
Transmitter.
If the system is in the
disarmed state, a "Low Battery" message
will be displayed. If the system is in the
armed state, this display message may
not appear until the system is disarmed
(depending on how the system was pro-
grammed).
4. If Downloading is in progress. Dur-
ing this period, the Alpha keypad will
display "MODEM COMM" and the fixed-
word keypad will display "CC."
5. If there is failure of communication
with the central alarm monitoring
station. If the system has attempted to
send a report to the central alarm moni-
toring station and has failed, the Alpha
keypad will display "COMM FAILURE"
and the Fixed-word keypad will display
"FC."
SEE
SYSTEM
5-3
Advertisement
Table of Contents
