Installation - Qilive Q.6899 User Manual

4. INSTALLATION

Warning!
Disconnect the appliance from the wall outlet before you install the appliance.
4.1 Unpack all parts.
After unpacking, check for completeness of delivery and for shipping damage. If your
delivery is damaged or incomplete, please contact our after-sales service.
4.2 Choose an appropriate location
Warning!
Position the appliance so that it is not exposed to direct sunlight. This appliance
should not be used outdoors or exposed to rain.
Warning!
The appliance must be separated by a distance of at least 50 cm from heat
sources (such as stoves, ovens, radiators, etc.) and at least 5 cm from electric
ovens.
Warning!
Install the appliance in a place where the power plug is easily accessible for
power disconnection.
1. Place the appliance in a well ventilated room on a dry, stable and level surface, away
from direct sunlight and other heat sources.
2. Ensure sufficient air circulation at the rear of the appliance. Do not place the
appliance against a wall to avoid noise caused by vibration. Make sure that the air
can still circulate freely around the appliance. Insufficient ventilation would result
in malfunction and increased energy consumption. Leave a space of at least
10 cm between the appliance and the wall, and at least 30 cm between the top of the
appliance and the ceiling.
3. Leave enough space to access and open the door easily (W x D ≥ 967×1226 mm).
( Fig. 1). If necessary, change the direction of door opening as described below.
4.3 Level feet
If the appliance tilts in some way, adjust the height of the left/right foot (4) of the appliance
to be in a horizontal level ( Fig. 2).
Turn the foot (4) clockwise or counter clockwise to adjust the height.
Note: If the appliance is not level, the door and the door seal will not be closed properly.
4.4 Reverse door
Ensure the appliance is unplugged and empty. To take the door off, it is necessary to tilt
the appliance backwards. You should rest the appliance on something solid so that it will
W
Fig. 1
Fig. 2
9
EN