Table of Contents
Advertisement
Quick Links
Solar Inverter
VSN300 WIFI LOGGER CARD
Quick Installation Guide
In addition to what is explained in this quick installation guide, the safety and installation information provided in the product manual must be read and
followed. The technical documentation for the product is available at the website.
The device must be used in the manner described in the manual. If this is not the case the safety devices guaranteed by the inverter might be
ineffective.
Advertisement
Table of Contents
Related Manuals for Fimer VSN300
Summary of Contents for Fimer VSN300
- Page 1 Solar Inverter VSN300 WIFI LOGGER CARD Quick Installation Guide In addition to what is explained in this quick installation guide, the safety and installation information provided in the product manual must be read and followed. The technical documentation for the product is available at the website.
-
Page 2: Operating Diagram
When the inverter is connected to the WLAN network with Internet access, the VSN300 WIFI LOGGER CARD allows for transfer of data to the Aurora Vision® Plant Management Platform for remote monitoring purposes over an Internet browser or Mobile App (Plant Viewer for Mobile) -
Page 3: Main Components
Mechanical mounting bracket 4. Enviroment and obstacles evaluation The communication among VSN300 WIFI LOGGER CARD and router is based on WiFi signal that could be limited by obstacles and distance. ATTENTION – The device must be kept away from large metal... -
Page 4: List Of Supplied Components
Main components Quantity ATTENTION – The VSN300 WIFI LOGGER CARD must be installed only by trained professional installers Locking screw - Turn off the inverter by physically disconnecting the AC and DC voltages, as well as any voltage connected to the multifunction relay. - Page 5 FCC ID of the VSN300 WIFI LOGGER CARD. - Identification label. This label is necessary to remember all the identification data of VSN300 WIFI LOGGER CARD and it should be applied in the dedi- cated area (see paragraph 10).
-
Page 6: Status Led Behavior
The VSN300 WIFI LOGGER CARD is equipped with 3 status LEDs that can behaves as follows: 4c. The VSN300 is able to operate in two different modes of operation: • “AP mode” (access point): in this mode is enabled local monitoring only. -
Page 7: Identification Label
9. Identification label This label is necessary to remember all the identification data of VSN300 WIFI LOGGER CARD and it should be applied in the dedicated area shown below. FIMER VSN300 WIFI LOGGER CARD APPLY HERE THE SN: YYWWSSSSSS IDENTIFICATION LABEL... - Page 8 FIMER does not accept any responsibility contents – in whole or in parts – is forbidden without prior whatsoever for potential errors or possible lack of written consent of FIMER.
Need help?
Do you have a question about the VSN300 and is the answer not in the manual?
Questions and answers