Restore The Network Settings To Factory Default; Entering Text For Wireless Settings - Brother MFC MFC-790CW Quick Setup Manual

For Wireless Network Users

Restore the network settings to factory default

To restore all network settings of the internal Print/Scan server to factory default, please follow the steps below.
a
Make sure the machine is not operating, then disconnect all the cables from the machine (except the power
cord).
b
Press MENU.
c
Press a or b to display Network and press Network.
d
Press a or b to display Factory Reset and press Factory Reset.
e
Press Yes.
f
Hold down Yes for 2 seconds to confirm.
g
The machine will restart, re-connect cables once this is complete.

Entering Text for Wireless Settings

When you are setting certain menu selections, you may need to enter text into the machine. Press
numbers, characters and special characters. Up to four letters are assigned to each button on the Touchscreen.
By pressing the correct button repeatedly, you can access the character you want.
Inserting spaces
To enter a space, press
Note
The characters available may differ depending on your country.
Making corrections
If you entered an incorrect letter and want to change it, use the arrow buttons to move the cursor under the
incorrect character. Then press
cursor and entering a character.
Repeating letters
If you need to enter a letter that is on the same button as the letter before, press c to move the cursor to the right
before you press the button again.
to choose special characters, then press the space button
. Re-enter the correct character. You can also insert letters by moving the
OK
or
to choose
.
49