Web Based Management (Web Browser); Print The Network Configuration List; Restore The Network Settings To Factory Default - Brother MFC-9320CW Quick Setup Manual

For Network Users
Web Based Management
(web browser)
The Brother print server is equipped with a web server
that allows you to monitor its status or change some
of its configuration settings, using HTTP (Hyper Text
Transfer Protocol).
Note
• The User Name is 'admin' and the default
password is 'access'. You can use a web
browser to change this password.
• We recommend Microsoft
6.0 (or higher) or Firefox 1.0 (or higher) for
®
Windows and Safari 1.3 for Macintosh.
Please also make sure that JavaScript and
cookies are always enabled in whichever
browser you use. To use a web browser, you
will need to know the IP address of the print
server. The IP address of the print server is
listed on the Network Configuration List.
a
Open your browser.
b
Type http:// printer_ip_address /into your
browser (Where "printer_ip_address" is the IP
address of the printer or the print server name).
For example http://192.168.1.2/

See Chapter 11 of the Network User's Guide.
46
® ®
Internet Explorer
Print the Network
Configuration List
You can print the Network Configuration List to
confirm the current network settings. To print the
Network Configuration List:
a
Turn on the machine and wait until the machine
is in the Ready state.
b
Press Menu, 6, 6.
Print Reports
6.Network Config
c
Press Start.
The machine will print the current network
settings.
Restore the network settings to
factory default
To restore all network settings of the internal
Print/Scan server to factory default, please follow the
steps below.
a
Make sure the machine is not operating, then
disconnect all the cables from the machine
(except the power cord).
b
Press Menu, 7, 0.
Network
0.Network Reset
c
Press 1 to choose Reset.
d
Press 1 to choose Yes.
e
The machine will restart, re-connect cables
once this is complete.