Recycling And Disposal - Riello STEEL PRO POWER Installation, Technical Assistance Service And System Management Manual

SYSTEM MANAGER
MODBUS CONNECTION
Register Automatic
Access Description Note
number conversion
Minimum
value
that
can be
510 X X assigned NV Yes
to the
heating
set-point
(Par. 23)
Night-time
511 X X attenuation NV Yes
(Par. 28)
In the "Note" column, the registers marked with "V" can be
written on an ongoing basis (and be used for dynamic size con-
trol). Registers marked with "NV", on the other hand, can be
overwritten only for a limited number of times (around 10,000
times with an average of twice a day).
Service reminder
Access
Register Automatic
Description
number conversion
L S
Hours
elapsed
1500 X from the last
maintenance
activity
Hours from
the next
1501 X
maintenance
activity
STATUS table
Nr. Name Description
0 STANDBY Standby
10 ALARM Non-volatile lockout error
14 BLOCK Volatile lockout error
15 FROST_PROTECT Frost protection on
16 CH_DEMAND Heat demand
17 RESET_STATE Reset
STORAGE_DE-
18 DHW demand
MAND
DHW_TAP_DE-
19 Imm. DHW demand.
MAND
20 DHW_PRE_HEAT Pre-heating demand
STORE_HOLD_
21 Holding desired storage temperature
WARM
GENERAL_
22 General pump ON
PUMPING
STATE table
Value Nr. Name Description
range
0 RESET_0 Initialisation of reset variables
1 RESET_1 Reset
2 STANDBY_0 Standby
3 PRE_PURGE Initialisation of pre-purging variables
Depends
on °C/°F
4 PRE_PURGE_1 Pre-purging
units
5 SAFETY_ON ON safety relay test
6 SAFETY_OFF OFF safety relay test
7 IGNIT_0 Initialisation of ignition variables
Depends
on °C/°F
8 IGNIT_1 Start-up
units
9 BURN_0 The module is ON
SHUT_DOWN_ Initialisation of variables to check
10
RELAY_TEST_0 safety devices and gas valve
SHUT_DOWN_
11 Safety and gas valve test relay
RELAY_TEST_1
Initialisation of post-purging varia-
12 POST_PURGE_0
bles
Value
range
13 POST_PURGE_1 Post-purging
Initialisation of heating pump varia-
14 PUMP_CH_0
bles
0...65534
15 PUMP_CH_1 Heating pump
hours
16 PUMP_HW_0 Initialisation of DHW pump variables
17 PUMP_HW_1 DHW pump
18 ALARM_1 Non-volatile lockout error
.. 0...2000
19 ERROR_CHECK Volatile lockout error
20 BURNER_BOOT Restart of board
CLEAR_E2PROM_
21 Cancel error E2PROM
ERROR
STORE_BLOCK_
22 Save error
ERROR
23 WAIT_A_SECOND Waiting before entering another state
114
SYSTEM MANAGER

9 RECYCLING AND DISPOSAL

The appliance is manufactured using various materials, such as metal, plastics, and electric and electronic components. At the end
of the life cycle, safely remove the components and dispose of them in a responsible manner, in compliance with the installation
country's applicable environmental legislation.
9
Adequate sorted waste collection, processing and environmentally-friendly disposal contribute to preventing possible nega-
tive impacts on the environment and health and promote the reuse and/or recycling of the materials of which the appliance
consists.
9
Illegal disposal of the product by the owner shall be subject to administrative fines provided for by applicable laws.
RECYCLING AND DISPOSAL
115