Maintenance - BorMann Technik BID3000 Owner's Manual

HANDLE ELECTRIC DRILL is a handle electric tool with two - fold insulation, drived by the. series
generation. Its features are small in vol-ume, light in weight, convenient to catch etc. It can be used in
places which is moist and nar.row. it can be used in the workshop with good conduct electricty,such
as work high above the ground or metal frame etc.
II. INSTRUCTION OF SAFETY,USE MAINTENANCE
Read the explanation following before the tool got through power. SAFETY
TECHNICAL RULES ON MANAGEMENT, USE, CHECKING AND SAFE MAINTENANCE Of THE HANDLE
ELECTRIC TOOLS. Otherwise you must obey our explanation first.
2. REGULARIZING WORKPIECE The work piece to be drilled must be regularized and pay more
attention to it when it is drilled through.
3. Use the plug correctly without changing the plug as one please and pluging the outlet with bare
conducting wire directly not using the plug. Be sure to take off the plug in time.
4. Not to use power wire without limited. Be sure not to lengthen or change the power wire, not to
carry the power wire touch heat source and oil. Prevent the from being damaged.
OPERATION
1. USE ASSIGNED VOLTAGE The voltage in the circuit must be not more than 10% at the data
plate assignment before using it.
2. CHECK BEFORE ΒΕING USED Let the tool have non loading for one minute and see whether
the function of transmission position is fiexible and the there is abnormal noise and the
screws become flexible and fall off and the erting sparkle is normal or not.
3. PREVENT THE TOOL FROM OVERLOAD The head of the driII must be sharp. When you are
drilling, you should not be too tough. If the rotation speed is reduced abnormally, you should
reduce to exert yourself. If the drill stops suddenly or gets stuck, you turn off the power.
4. CHANGE THE BRUSH IN TIME If th!;! brushes are too damaged to use, change them both at
the same time, otherwise the brushes and the inverter Will be in loose contact even, sparkle
around or the inverter can be damaged. Sometimes the armature would be burnt.
5. It cannot be used in the following condition. If you find the insulate is damaged, the power
wire or electric cable case is broken, the plug and outlet is broken, and it works continually
the sparkle appears seriously etc. you should repair immediately. It cannot be used before
being repaired.
6. USE THE TOOL CAREFULLY The tool used should be placed s-oftly in order not to be shocked.

MAINTENANCE:

1. ADD OIL IN IT OF TEN The drill is a speed working tool. The lubrication grease is volatilized easily so
the grease in reduction case a-nd bearing must often be kept clean and add or change it anytime
needed.
2. CHECKING AND MAINTENANCE ONIT FREQUENTLY The drill should be checked, everyday by day
and if necessary let' it be repaired, the inter wiring the plug and the switch work well .or not. Pay
attention to everything such as whether the insulation resistance works normally ,the handle is
flexible, the inverter and brushes are well contacted. the armature winding and the stator winding are
in short circuit or broken circuit, and the bearing, the other moving parts are damaged etc.
4
www.BormannTools.com