Table of Contents
Advertisement
EN
Operating Instructions
Always observe the safety instructions and any applicable regulations.
Observe and be sure of the correct mains voltage!
The voltage of the power source must agree with the voltage specified on the nameplate of the machine/power
tool.
Switching ΟN and ΟFF
• To start the power tool, press the OΝ/OFF switch and keep it pressed.
To lock the pressed ON/OFF switch, press the lock-on button.
• To switch off the machine, release the ON / OFF switch or when it is locked with the Iock-on button, rapidly press the ON/OFF
switch and then release it.
Maintenance
Your Bormann PRO power tool has been designed to operate over a long period of time with minimum maintenance
needs.
Cleaning
Keep the ventilation slots clean and clear and regularly clean the housing using a soft cloth.
Disposal
The power tool, accessories and packaging should be sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According the European Guideline 2002/96/EC for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that are no longer usable must be collected separately and
disposed of in an environmentally correct manner.
5
Lubrication
All models equipped with a lubrication system cap must be lubricated.
Caution Prior to lubrication, always disconnect the plug from the power supply socket.
1. Before feeding grease, use the wrench to remove the lubrication container cap. Be careful not to
lose the rubber packing attached below the grease gauge.
2. Check the grease level periodically, confirming that grease is filled.
3. After feeding grease, securely clamp the grease gauge.
WWW.NIKOLAOUTOOLS.COM
Advertisement
Table of Contents
