Advertisement
Available languages
Available languages
3. EACH PART SHOULD BE WELL KEPT AND WHEN You WANT TO CHANGE THE PART, USING THE SAME
ONES When the drill needs ta-king apart and checking, do keep each part includi.ng insulation liner
a-nd casing pipe. If they are damaged you must change the new one and the same one, Be sure not to
use the substiutiom materials which is w-orse than one one used and the parts which does not agree
with the standard. When fixing, you must put the parts in their proper position as usual and should
not omit any of them.
4. BE CAREFUL OF THE INSULATION RESISTANCE. The drill not to be used for long or to have been
used in damp condition must be t-ested in its winding of the insulation resistance with a 500 million
ohm meter. If the winding and iron center is less than 2 million ohms, you must make drying
treatment to the winding until more than 2 million ohms.
5. STORED CAREFULLY the drill should be kept in a clean place and without any corrosive gases.
ΙΙΙ. ACCESSORIES
If the drill manufactured by our factory is damaged or cannot work no mole for the quality, we will
repair it free within one year since the date of manufacture of being bought within six months.
NOTE: To be sure obey the rules and use and keep it correctly and disassemble by yourself except to
change the brushes.
5
www.BormannTools.com
Advertisement
