Related Manuals for Ecoair APOLLO MK2
Summary of Contents for Ecoair APOLLO MK2
- Page 1 APOLLO MK2 PAC-100013 Portable Air Conditioner Please read instructions before use. Keep a copy for future reference.
-
Page 2: Table Of Contents
Installation ............................. 9 - 10 Installation of Drainage ....................... 11 - 12 Quick Set Up ..........................13 - 16 Cleaning And Maintenance ......................17 - 18 Troubleshooting .......................... 19 - 21 © 2021 EcoAir - V2 All rights reserved (E&OE) -
Page 3: Important Safety Instructions
• Children and pets should be supervised to ensure they do not play with the appliance. • If the power cable is damaged, do not use the appliance. It must be replaced by an EcoAir’s Authorised Service Center. • The appliance must be plugged into a grounded 3-prong outlet and ensure that the voltage matches the rated specifications. -
Page 4: The Refrigerant R290 Gas
Never attempt to service or repair the appliances yourself, always ensure it is only serviced by a EcoAir approved engineer using original EcoAir parts. If these appliances are installed, operated or stored in a non-ventilated area, then the room must be designed to prevent the accumulation of refrigerant leaks. -
Page 5: Bs Plug Wiring
Wiring for a 13 Amp Plug (BS1363) Please note. The Earth Terminal is marked with the letter E or Earth Symbol. Earth - (Green/Yellow) Neutral - N (Blue) Live - L (Brown) © 2021 EcoAir - V2 All rights reserved (E&OE) -
Page 6: The Appliance And Accessories
Air Outlet Louvre (Vertical) Joint B + C (Hose to Window) Castor Cable Tidy Cable Tidy Screw x 2 Plug of power cord User Manual Filter Remote Control Air Inlet Grille Remote Control Compartment © 2021 EcoAir - V2 All rights reserved (E&OE) - Page 7 Excess Drainage Kit (For Heat and Dry Modes Only) - To be purchased separately DESCRIPTION Description Drainage Connector Continuous Drainage Hose 14mm (not included) Hose (10mm) Rubber Stopper Pipe Clamp Screw © 2021 EcoAir - V2 All rights reserved (E&OE)
-
Page 8: Read Before Installation
16°C. Do note operate the appliance where the temperature is below 16°C to avoid frosting of the coils consequently reducing its performance. Appliance in this picture is for illustration purpose only © 2021 EcoAir - V2 All rights reserved (E&OE) - Page 9 READ BEFORE INSTALLATION INSTALLATION OF EXHAUST HOSE EXHAUST HOSE CONNECTION Only use the exhaust hose B2 supplied. The length of the exhaust hose B2 must not be longer than 1.5 meters. © 2021 EcoAir - V2 All rights reserved (E&OE)
-
Page 10: Installation
EXHAUST HOSE Connect together Joint B to Joint C (B3) Attach Joint A (B1) to Exhaust Hose (B2) Joint A (Hose to AC) Clip together Exhaust Hose B2 Joint C Joint B © 2021 EcoAir - V2 All rights reserved (E&OE) - Page 11 STEP 6B. DISCHARGE EXHAUST HOSE (B2) THROUGH A WINDOW GAP Pre-seal the window with a Window Seal Nylon Cloth (available for purchase) Pass the exhaust hose B2 (with or without Joint B B3 attached) through the zipped opening. © 2021 EcoAir - V2 All rights reserved (E&OE)
-
Page 12: Installation Of Drainage
(without any kinks or upward angles) Do not submerge the end of the drainage hose in water (this will cause back pressure and the water will not drain. Drainage port Drainage hose © 2021 EcoAir - V2 All rights reserved (E&OE) - Page 13 STEP 1. UNPLUG THE PORT DRAINAGE STEP 2. SCREW IN THE PIPE CLAMP (D3) TO STOPPER THE BACK PANEL Drainage Port STEP 3. AFFIX THE EXCESS DRAINAGE HOSE Rubber Stopper Pipe Clamp Hose Drainage Port © 2021 EcoAir - V2 All rights reserved (E&OE)
-
Page 14: Quick Set Up
HEAT: When heating mode indicator is on, the appliance will operate in heating mode. Display shows the set temperature. Recommended to use continuous drainage in this mode otherwise water needs to be drained frequently. © 2021 EcoAir - V2 All rights reserved (E&OE) - Page 15 Use this mode for bedtime, the appliance will reduce the cooling as you fall asleep since our body temperature tends to come down during that period. © 2021 EcoAir - V2 All rights reserved (E&OE)
- Page 16 Timer On Timer Off Sending signal Auto operation Swing (Not applicable for this appliance) Cool operation Sleep operation Dry operation Lock Fan operation Set speed Heat operation Set temperature Set time © 2021 EcoAir - V2 All rights reserved (E&OE)
- Page 17 VERTICAL DIRECTION Hold the horizontal louvres and move up or Hold the vertical louvres and move left or down for your comfort. right. NOTE: Do not close the air flow completely. © 2021 EcoAir - V2 All rights reserved (E&OE)
-
Page 18: Cleaning And Maintenance
Use vacuum cleaner, brush or water to clean the The filter should be cleaned at least once filter. every two weeks. For dusty environment, you should increase the cleaning frequency . © 2021 EcoAir - V2 All rights reserved (E&OE) - Page 19 Clean the appliance and pack it well to prevent dust. REPLACING BATTERIES battery Gently slide the battery cover to remove. Replace two (AAA 1.5V) dry batteries and make sure the positions of plus and minus polar are correct. battery cover © 2021 EcoAir - V2 All rights reserved (E&OE)
-
Page 20: Troubleshooting
Switch off until the humidity level reduces. Clean the filters. Ensure there is at least 50 cm air space around the appliance for sufficient ventilation. Overload malfunction If error persist, contact technical. © 2021 EcoAir - V2 All rights reserved (E&OE) - Page 21 Remote control signal blocked Move away the obstacles. by obstacles. Remote Control is not sensible Appliance does not respond to Replace the batteries. the remote control. © 2021 EcoAir - V2 All rights reserved (E&OE)
- Page 22 This is normal action for refrigerant flow appliance. and water evaporation. appliance In the unlikely event of a problem with your product, please refer in the first instance to: ECOAIR TECHNICAL SUPPORT www.ecoair.org/support © 2021 EcoAir - V2 All rights reserved (E&OE)
- Page 24 66139900672...