Advertisement
Association
This machine provides a group of
nodes. Each group can set 5 Nodes.
Group 1: Used for returned events.
Report type:
1.Notification report
2.Sensor multilevel report
3.Rest report
※Adding a node ID allocated by Z-Wave Controller means inclusion. Removing a
node ID allocated by Z-Wave Controller means exclusion.
※Failed or success in including/excluding the node ID can be viewed from the Z-
Wave Controller.
LED Indication
To distinguish what mode the switch is in, view the LED light description for
identification.
State Type
LED Indication
No node ID
Under normal operation, when the Switch has not been allocated a
node ID, the LED light will flash on and off alternately at 120 second
intervals. By pressing On/Off button, the light will stop flashing
temporarily.
Learning
When the PAT12 is in learning mode, if the learning code is success-
ful, the LED light will flash slowly.
Z-Wave Message Report
*CO2 Report:
When the CO2 Concentration differential over 1 percent(in default) or across the
baseline level , the device will unsolicited to send the " Sensor Multilevel Report " to
the nodes in the group 1.
Multilevel Sensor Report
Sensor Type : CO2 (0x11)
Note:
1.This function default is enabled, to disable this function by setting the configuration
NO.2 to zero.
2.Baseline level default is disable, to enable this function by setting the configuration
NO.3、NO.4、NO.5、NO.6、NO.7.
*Tamper Report:
The tamper key pressed over 8 seconds.The device will into the alarm state. In that
state, if the tamper key be released, the device will unsolicited to send the report to
the nodes in the group1.
Notification Report
Notification Type : Home Security (0x07)
Event : Tampering. Product covering removed (0x03)
*Timing Report:
•
CO2 report: Every 1 hours report once in default.
It could be changed by setting the configuration NO.1.
Over The Air (OTA) Firmware Update
The device supports Z-Wave firmware update via OTA.
3
Advertisement
