Fujitsu ETERNUS DX60 S3 Site Planning Manual page 11

Chapter 1 ETERNUS DX Installation
1.1 Installation Specifications
Item
Maximum heat
generation (*2)
Maximum amount
of exhaust air
Environmental
conditions
Vibration limit
Noise emission
(*3)
*1: A 2U power distribution unit is composed of two 1U power distribution units.
*2: These values are for each drive enclosure when 24 drives are installed in a 2.5" type drive enclosure or
12 drives are installed in a 3.5" type drive enclosure.
*3: These values are measured when a single controller enclosure and drive enclosure are configured in an
environment in which the temperature is 23 ± 2°C.
Controller enclo- 2.5" type
sure
3.5" type
Drive enclosure 2.5" type
3.5" type
Controller enclosure
Drive enclosure
Temperature
Temperature gradient
Humidity
Humidity gradient
Maximum wet bulb temperature
Altitude above sea level
Airborne dust
Gas concentration tolerance level
Oil vapor
Seawater (salt corrosion)
Operating
Not operating
Sound pressure level
Sound power level
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Site Planning Guide
Copyright 2015 FUJITSU LIMITED
ETERNUS DX60 S3
AC 100 – 120V 2,200kJ/h
AC 200 – 240V 2,200kJ/h
AC 100 – 120V 2,000kJ/h
AC 200 – 240V 2,000kJ/h
AC 100 – 120V 1,600kJ/h
AC 200 – 240V 1,600kJ/h
AC 100 – 120V 1,300kJ/h
AC 200 – 240V 1,300kJ/h
2.5" type
4.0m
3.5" type
4.0m
2.5" type
4.0m
3.5" type
4.0m
Operating 10 – 40°C
Not operating 0 – 50°C
Shipping -40 – 60°C
15°C/Hr or less
Operating 20 – 80%RH
Not operating 8 – 80%RH
Shipping 8 – 90%RH
30%/day or less
29°C
0 – 3000m
0.15mg/m
Cl
SO
NO
6.6ppb or less, HF: 3.6ppb or less
0.2mg/m
If the ETERNUS DX is installed on the ocean
or premises within 0.5km from the coast,
necessary measures must be taken to pre-
vent salt corrosion.
400gal
1,000gal
49dB (A)
6.7B
11
3
/min
3
/min
3
/min
3
/min
3
or less
: 3.4ppb or less, H S: 7.1ppb or less,
2 2
: 37ppb or less, NH : 420ppb or less,
2 3
: 52ppb or less, O : 5ppb or less, HCl:
2 3
3
or less
P3AM-8982-03ENZ0