Care And Cleaning - Hyundai H-VCC05 Instruction Manual

6.
"XX" is the month of production, and following four figures "XXXX" is the year of
production.
PREPARATION

Unpack the device and remove the sticker from the body.

In order to connect the hose to the vacuum cleaner insert hose base into sucking inlet
and press gently until it clicks. In order to disconnect the hose press two locks
located at hose base sides.

Pull out the retractable tube until the necessary length is reached. For this purpose
move the retractable tube length adjuster and pull out the tube end.

Insert the hose into the tube.

Attach one of the nozzles to the tube:

The "Floor/cfrpet" combined nozzle is designed for carpet mats and similar floor
coatings, and for flat surfaces;

The "Furniture/slot" nozzle is designed for cleaning upholstered furniture, curtains and
decorative surfaces and
such as corners or narrow slots.
INSTRUCTION FOR USE

"Cyclone" system ensures maximum power during cleaning.

Before starting, unwind the cord to sufficient length and insert the plug into the power
supply. The yellow mark on the cord shows optimal cord length. Do not unwind the
cord beyond the red mark.

Press On/Off button to switch the unit on and press again to stop it.

You can adjust the air flow using the air flow regulator on the flexible hose handle:

Decrease flow for cleaning curtains, books, furniture, etc. Increase flow for cleaning
bare floor.

To rewind the cord, press the rewind button and guide the cord with hand to ensure
that it does not whip causing damage.

To prevent motor overheating do not work continuously longer than 30 minutes and
obligatory stop the vacuum cleaner for no less than 15 min.

The housing is equipped with the power regulator used to adjust sucking force to the
type of the surface being cleaned.

WARNING!

Be sure to clean the container after each cleaning.

Never use the vacuum cleaner without installed filter and with damaged or dirty filter.
Otherwise, dust will fall into the motor and cause damage to the vacuum cleaner.

Don't use the vacuum cleaner if the container is filled to the mark ""MAX"". When the
container is filled, dirty air clogs up the vacuum cleaner filter and the engine can
overheat and disable.

Don't use the vacuum cleaner for cleaning of material debris such as cement,
whitewash, plaster, metal shavings and etc. These particles cause to the engine
damage.

Don't wash vacuum cleaner parts in a dishwasher or a construction machine.

CARE AND CLEANING


Switch off the appliance and pull the plug from the power supply.

For removing dust tank press dust tank release button.

We recommend making the filtration system clean up after every using.

To open the dust tank bottom and clean dust and garbage need to press the button
for opening the bottom of the dust tank.