Power Fist 12V Bar Mount User Manual page 6

8670838
2. Protect yourself against electric shocks when working on electrical
equipment. Avoid body contact with grounded surfaces. There is an
increased chance of electrical shock if your body is grounded.
3. Do not expose tool to rain or wet conditions. Water entering a power tool
will increase the risk of electric shock.
4. Do not disconnect the leads in place of using the ON/OFF switch on the
tool. This will prevent an accidental startup when the leads are connected
to the power supply.
5. Do not alter any parts of the tool or accessories. All parts and accessories are
designed with built-in safety features that may be compromised if altered.
6. Make certain the power source conforms to requirements of your
equipment (see Specifications).
BATTERY LEADS SAFETY
WARNING! DO NOT touch the two clamps together while the unit is
connected to a vehicle battery. This will cause a discharge and may result
in electrocution.
1. Do not operate this tool if the leads are frayed or damaged as an electric
shock or surge may occur, resulting in personal injury or property damage.
a. Inspect the leads for cracks, fraying or other faults in the insulation
before each use.
b. Discontinue use if the leads feel more than comfortably warm while
operating the tool.
2. Keep all connections dry and off the ground to reduce the risk of electric
shock. Do not touch the leads with wet hands.
3. Prevent damage to the leads by observing the following:
a. Keep the leads away from heat, oil, sharp edges or moving parts.
b. Place the leads in a position that prevents them from coming into
contact with the tool and from getting caught by the workpiece. The
leads should always stay behind the tool.
4. Do not allow people, mobile equipment or vehicles to pass over
unprotected leads.
a. Position the leads away from traffic areas.
6
12V Bar Mount Chainsaw Sharpener
For technical questions call 1-800-665-8685
V4.0