Husqvarna 525DEPS Operator's Manual page 17

Hide thumbs Also See for 525DEPS:
Table of Contents

Advertisement

Available languages

Available languages

Maintenance
Check the saw chain with regard to visible cracks in the rivets and links,
whether the saw chain is stiff or whether the rivets and links are abnormally
worn.
Clean the area under the protective cover.
Make sure that the screws and nuts are tight.
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the cooling system.
Examine the starter and the starter rope for damages.
Examine the vibration damping elements for damages and cracks.
Clean the outside of the spark plug. Remove it and do a check of the elec-
trode gap. Adjust the gap to the correct distance (refer to
page 25 ) or replace the spark plug. Make sure that the spark plug is fitted
with a suppressor.
Clean the outside of the carburetor and the space around it.
File off any burrs from the edges of the bar.
Clean or replace the spark arrester screen on the muffler.
Lubricate the shafts.
Apply dielectric grease to the shaft coupling.
Clean the fuel tank.
Do a check of the fuel filter for contamination and the fuel hose for cracks
or other defects. Replace if necessary.
Do a check of all cables and connections.
Do a check of the clutch, clutch springs and the clutch drum for wear. Re-
place if necessary by an authorized service workshop.
Examine the spark plug. Replace the spark plug if it is necessary.
Do an inspection of the dielectric shaft for worn and damaged areas. Do not
use the product if the dielectric shaft has worn or damaged areas. Refer to
OSHA 1910.269 for more information.
To adjust the idle speed
1. Make sure that the air filter is clean and the air
filter cover is attached before you adjust the idle
speed.
2. Start the product. Refer to
page 14
1480 - 007 - 15.02.2021
To start the product on
Technical data on
3. Adjust the idle speed with the idle adjustment
screw T which is identified with "T" mark. Turn
the idle adjustment screw clockwise until the saw
chain starts to turn.
4. Turn the idle adjustment screw counterclockwise
until the saw chain stops.
Weekly
Daily
(30
Monthly
hours)
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Madsaw 525deps

Table of Contents