Transportation, Storage And Disposal; Technical Data - Husqvarna 525DEPS Operator's Manual

The engine starts but stops again
Check
Fuel tank
Air filter
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from
electrical devices or boilers, can start a fire.
• Stop the product and let it become cool before
you disassemble it.
• This product is a special tool with a dielectric
shaft section. The dielectric shaft section must be
removed and kept in a safe location for storage
and transportation. Do not put the product into
storage assembled.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel and chain oil tanks before
transportation or before long-term storage.
Discard the fuel and chain oil at an applicable
disposal location.
• Use the transportation guard on the product to
prevent injuries or damage to the product. A saw
chain that does not move can also cause serious
injuries.

Technical data

Engine
Cylinder displacement, in
Cylinder bore, in/mm
Stroke, in/mm
Recommended max. speed, rpm
Idle speed, rpm
Max. engine output, according to ISO 8893, kW/rpm
Catalytic converter muffler
Speed-regulated ignition system
Ignition system
1480 - 007 - 15.02.2021
Possible cause
Incorrect fuel type.
The air filter is clogged.

Transportation, storage and disposal

Technical data
3 3
/cm
Procedure
Empty the fuel tank and fill it with correct
fuel.
Clean the air filter.
• Remove the spark plug cap from the spark plug.
• Attach the product safely during transportation.
To prepare your product for long-
term storage
1. Stop the product and let it become cool before
you disassemble it.
2. Disassemble and clean the saw chain and the
groove in the guide bar.
CAUTION:
guide bar are not cleaned, they can
become rigid or blocked.
3. Attach the transportation guard.
4. Clean the product. Refer to
page 16 for instructions.
5. Do a complete servicing of the product.
1.55/25.4
1.34/34
1.10/28
11000-12000
2800-3000
1.0/8500
Yes
Yes
If the saw chain and
Maintenance on
25