Husqvarna 525DEPS Operator's Manual page 14

replace the fuel filter one time a year or
more.
To use the correct chain oil
WARNING:
which can cause injury to you and the
environment. Waste oil also causes
damage to the oil pump, the guide bar
and the saw chain.
WARNING:
break if the lubrication of the cutting
equipment is not sufficient. Risk of
serious injury or death to the operator.
WARNING:
function that lets the fuel run out before
the chain oil. Use the correct chain oil for
this safety function to operate correctly.
Speak to your servicing dealer when you
select your chain oil.
Note:
This product has an automatic chain
lubrication system. You can also adjust the oil flow.
To adjust the chain lubrication on page 24 .
Refer to
• Use only Husqvarna dielectric chain oil.
CAUTION:
runs out before the fuel. In
temperatures below 0°C/32°F some
chain oils become too thick, which
can cause damage to the oil pump
components.
• Use the recommended cutting equipment. Refer
to Recommended cutting equipment on page
26 .
To prepare the product for start
1. Push the air purge bulb 10 times.
Note:
It is not necessary to fully fill the bulb.
14
Do not use waste oil,
The saw chain can
This product has a
If the oil is too thin, it
2. Move the choke control up into choke position.
WARNING:
start to rotate immediately when you
start the engine with the choke.
To start the product
WARNING:
instructions in the safety chapter before
you start the product (refer to
page 4 ).
1. Use protective gloves.
2. Hold the body of the product on the ground with
your left hand.
CAUTION:
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope with your right
hand until you feel some resistance (the starter
pawls grip).
WARNING:
starter rope around your hand.
5. Pull the cord quickly and with power.
CAUTION:
starter rope all the way out and do
not let go off the starter rope handle
when the starter rope is fully
extended. This can cause damage to
the product.
6. Pull the starter rope until the engine starts or for
a maximum of 5 times.
7. Reset the choke when the engine starts or after
you pull the starter rope 5 times.
8. If it is necessary, pull the starter rope again and
again until the engine starts.
9. Let the engine run for 10 seconds.
10. Operate the throttle gradually.
11. Make sure the engine runs smoothly.
The saw chain will
Read the warning
Safety on
Do not use your feet!
Do not twist the
Do not pull the
1480 - 007 - 15.02.2021